The Curt Trailer Hitch Receiver # C13587 is confirmed to fit all trim levels of you 2005 Mercury Monterey. This custom fit class III receiver is rated for maximum capacities of 3,500lbs towing and 350lbs of tongue weight. If you use a weight distribution hitch maximum capacities increase to 5,000lbs towing and 500lbs of tongue weight.
For towing small trailers you will need one of 2 wiring harnesses. If your Mercury has the plug for a factory towing harness behind the bumper you will... view full answer...
Yes the Advent Air Replacement RV Air Conditioner for Dometic Setup w/ Start Capacitor # ACDOM135 will work great as a replacement for your older Dometic Duo-Therm Air Conditioner.
This air conditioner requires a minimum frame thickness of 3/4", so since yours is over that, you're good to go.
Additionally, we do also offer this unit in black # ACDOM135B, if you're interested.
Both of these units have a 13,500 Btu cooling capacity, a 500 cubic feet/minute air flow rate, and will plug... view full answer...
You are correct, the even though the Hollywood Racks Express 3 Bike Carrier, # HRE3 is a confirmed fit on a 1999 Mercury Cougar but it does NOT work with spoilers at all. Instead, I would recommend the Hollywood Racks Expedition 2 # HRF6-2. It is designed to accommodate spoilers. You would use the tow loops on the side of the vehicle to attach straps or hooks, and use the holes located in the vehicle frame for attaching hooks. Check out the attached video. view full answer...
A 1-1/4 inch to 2 inch hitch adapter is not available for towing, those are for accessories like bike racks only. So if you want to tow with the 2003 Mercury Mountaineer you'd need to add a 2 inch hitch. The good news is there is a hitch designed to fit directly under the OEM hitch so you don't have to remove it, and what you'd need is the following:
- etrailer Trailer Hitch Receiver # e55KR
If you also need a 4-way wiring harness the correct part is the Vehicle Wiring Harness # HM40655. view full answer...
The Curt T-Connector Vehicle Wiring Harness, part # 118551, will work on your 2008 Mercury Mariner Hybrid whether or not it has the factory tow package.. I am including a link to the installation instructions and a video link to the wiring harness being installed on a 2007 Mercury Mariner. view full answer...
Sure thing, we can get your 2003 Mercury Mountaineer set up with a 7-way and brake controller. The first thing you will need is a 4-way if your Mercury doesn't have one, and then you'll plug that into the 7-way. The exact parts are as follows:
- T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 118344
- Universal Installation Kit for Trailer Brake Controller # ETBC7
- Curt Venturer Trailer Brake Controller # C74VV
- Universal Wiring Adapter for Curt Trailer Brake Controllers... view full answer...
Yes, If your 2008 Mercury Mariner has the factory cross bars that run from side to side on the top of the vehicle, the SportRack J-Stacker Kayak Carrier - Roof Mount, item # SR5511, will work on your vehicle. The J-Stacker will work on factory cross bars up to 3-1/2 inches diameter.
If your vehicle has factory side rails that run front to back, without cross bars, you will need cross bars. I would recommend the Thule Roof Rack For 2008 Mariner by Mercury, which consists of part # TH712100... view full answer...
What your trailer has is called a wishbone harness. It has 2 separate wires for the running light circuits, one for each side of the trailer. This is done so you do not have to splice a jumper from one side of the trailer to the other. It will work exactly the same way a regular 4-Way does so it is compatible with T-Connector harness # C55375. I have linked a video showing a typical installation and a link to the instructions for you. view full answer...
Yes, the Thule Hullavator Pro # TH898 can fit on the Malone Square bar roof rack part # MPG201 you have on your 2006 Mercury Mariner. Thanks for the kind words on our site! view full answer...
I do have a hitch cover and anti-rattle sleeve option for you, however, the Draw-Tite QSP Trailer Hitch Silencer and Cover part # 63080 will not fit a 2" Curt trailer hitch receiver as the collar on the outside of the hitch receiver is too large.
In order to cover the receiver opening on a 2" Curt trailer hitch receiver like part # 13707 I recommend using the Curt Rubber Tube Cover part # C22272. For anti-rattle purposes I recommend using the Brophy Stabilizer Bracket for 2" Hitch Receiver... view full answer...
The Prostrobe Rocky 8 Pro White Windshield Light # PRS70747 is not waterproof since it is intended to mount to the inside surface of a vehicle windshield using the included suction cup mounts. It is more than bright enough to shine through a windshield. It is so bright that the packaging includes a warning not to look directly at the light!
The standard cigarette lighter style plug (with 10-foot cord) fits into the power receptacle inside most vehicles.
The Rocky 8 uses LED technology... view full answer...
A 1-1/4 inch hitch receiver is either a Class I or Class II hitch. All Class I and Class II can only use the ball mounts that are recommended for that vehicle.
For safety reasons, if you have to change the rise or drop from the recommended ball mount, then the manufacturer does not recommend to tow that trailer with the Class I or Class II hitch on your vehicle.
We have Class III hitches available for Mercury Mountaineers that will bolt on underneath the OEM 1-1/4 hitch. The Class III... view full answer...
The WeatherTech Black Cargo Liner, # WT40197, fits your cargo area behind the 2nd row (last row) of seats. The measurements are hard to be specific on because it is a custom fit product. It comes rolled up, so it is hard to measure but here is what I found.
From front to rear the mat measures 36-1/2 inches, from side to side, in the back of the vehicle, the mat measures 48 inches, and between the wheel wells the mat measures 40-1/2 inches. Again these measurements are approximate but should... view full answer...
Before buying snow tire chains, you will want to check your owners manual or with the Mercury dealer to determine if you can install snow tire chains on your Mercury Montego, or if there are any limitations.
I would recommend the Thule XG12 Pro Self-Tensioning Snow Tire Chains, part # TH01594240. These chains will fit your Mercury Montego with the 225/55R18 tire size and are quick and easy to install. Since your vehicle is front wheel drive you will want to install them on the front tires.
These... view full answer...
I checked with Curt just now and they do show the front hitch part # 31545 as a confirmed fit for your 2010 Mercury Mountaineer so yes, this hitch will fit and work well for you. view full answer...
In order to carry a scooter on your 2002 Mercury Mountaineer your vehicle will need a new 2 inch trailer hitch. My research shows that your vehicle has the tongue capacity to carry the scooter and carrier, however, this is only if you do not use the adapter. When an adapter is used it cuts your tongue weight capacity in half.
In order to determine your tongue weight, please consult either your vehicle owners manual or your local dealership.
Carrying a hefty scooter like yours, plus the... view full answer...
The 4-Pole Hardwire Kit with Converter, part # 119178KIT is the correct trailer wiring harness for your Mercury Villager. The kit also includes quick splices for tapping into the existing wiring and a circuit tester for verifying your connections.
I have linked you to the install instructions, as well as to an install video that you might find helpful. The video shows the part being installed on a different vehicle, but the procedure would be similar for your Villager, especially the procedure... view full answer...
When you measure for a ballmount, you will want to measure from the ground up to the flat bottom part of your coupler, not inside of it. The 2-3/4 inch rise provided by the recommended ball mount would work just fine for you. That part number has been discontinued, but # EBMK4 will be a fit. view full answer...
The best way to find out if your 2006 Mercury Mariner has a factory tow package is to have the dealership run the VIN number of your vehicle. They will be able to tell you all the installed factory options the vehicle has.
If you are trying to decide if the Hopkins Wiring Harness, part # 40455, will fit your Mariner, there is another way that might help you determine if you have the factory tow package. You can look at the rear of the vehicle for the tow package connector that would be... view full answer...
Yes, the Thule OutWay 3, # TH56BV, will fit your 2003 Mercury Sable Wagon. I own this bike rack and it is the easiest to use bike rack that I have ever had. The 2 retractable cables make installation fast and easy. The rack also features an integrated cable lock in the last bike position to deter bike theft. And the cables can be locked into place to deter theft of the rack.
If you will be carrying any bikes that do not have a top frame bar that goes straight across (like a typical men's... view full answer...
Go To Results