4-1/4" x 1-11/16" Oval. Waterproof, LED light serves as a clearance or side marker light when properly mounted. Chrome bezel provides finished look. Surface mount to trailer. 2-Wire design with 0.180 male bullets. P2 Rated. Amber LEDs
Features:
Specs:
The waterproof construction of this light makes it ideal for use on trailers that may be submerged, like a boat trailer. The circuit board is sealed, which means that water will not damage the diodes or circuit board.
A P2-rated light produces a 45-degree angle of light to either side of its centerline for a total of 90 degrees of coverage. This beam pattern can be seen straight on, but it cannot be seen clearly from the side. So this type of light can be used as either a side marker light or a clearance light, but it cannot function as both. If you need both functions, then you must install 2 separate lights on your trailer - one as a front or rear clearance light and one as a side marker light.
Surface-mount trailer lights install using a flange or bracket with mounting holes. These lights lay flat against the trailer surface and only require a small, often pre-existing hole, for wiring. Mounting hardware is used to secure the light to the trailer.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're taking a look at the Optronics Millennium M5 LED Clearance or Side Marker light. This is an amber light. It features an oval LED design, so the oval LED trailer light functions as a clearance or side marker light when properly mounted on your trailer. It does come with the chrome bezel which provides a finished look that's gonna cover the installation hardware. It does feature a sealed waterproof housing and lens unit. It's LED, so LEDs make great replacements for incandescent lights, they last longer, they burn brighter and they're more efficient.
With LEDs you don't have to worry about replacing bulbs and you don't have to worry about brittle filaments.We're looking at a durable, polycarbonate housing and lens unit. We do have a clear lens over amber LEDs, and this is compatible with 12 volt DC systems. It's a two mount hole design. Surface mount installation, mounts directly to the surface of the trailer. Mounting hardware not included.
It's a two wire design, so one wire's your power wire, the other one's your ground wire, and the wires have the 0.180 male bullet connectors on 'em. It's department and transportation compliant, and it is a P2 rated light. When it comes to the dimensions, measuring edge to edge going this direction, it's about four and one quart inches. Edge to edge going this direction is about one and .. see there it's about one and three eighths to one and seven 16ths.
It's only about three quarters of an inch thick, so it is a nice load profile unit.The mount holes are separated on center by three and one eighth inches. We're gonna go and hook it up to power, that way you can see what it looks like with power running to it. We'll also turn off our overhead light so you can see it in a low light setting. So you can see here it sends out a really nice, clear, consistent signal. It's a three diode design, and again, it has a clear lens with the amber LEDs.
Power draw at 12.8 volts, 0.033 amps, and Optronics puts a lifetime warranty on the LEDs. That's gonna do it for today's look at the Millennium M5 LED Clearance or Side Marker Light.
Average Customer Rating: 4.9 out of 5 stars (9 Customer Reviews)
4-1/4" x 1-11/16" Oval. Waterproof, LED light serves as a clearance or side marker light when properly mounted. Chrome bezel provides finished look. Surface mount to trailer. 2-Wire design with 0.180 male bullets. P2 Rated. Amber LEDsGreat Quality Products and the arrive on time or early. Very Good Service as well!
Good morning!
I’m very happy to deal with etrailer, because of the excellent service they provide. By the way I want to bring to your attentions my mistake of choosing Millennium M5 instead of Optroniics led clearance which is the one I really need.
Thanks!
without the silver bezel this light is a match in color and fit for the fiberglass nose on my class-C RV. Looks really sharp too! Much better than the OE incandescent lights.
Great service and great product, just what we were looking for.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.