RV Floor Vent with Damper - 4" x 10" - Steel - Brown

Video Transcript for JR Products Dampered RV Floor Register Review

Shane: Hey guys, Shane here with etrailer.com. Today we're going to be taking a look at replacement registers for your camper or RV. These vents are going to be by JR Products. They're going to come in three different colors, they're going to come in black, white or brown. They're also going to come in dampered and un-dampered. So the reason we had to replace this one, as you can see this one's kind of bent.

With this being sticking up like this, it's an easy way to cut your foot. It's kind of bent here in the middle. If it gets bent like that, it can kind of close off the vent, which can restrict airflow.We look at our new one, this is going to be a metal construction. The damper, and what damper it is, is it allows you to open and close the vent to regulate how much heat or air you want inside that room. If you look at the old one that we replaced, it's un-dampered, so it doesn't allow you to close that off.

So if you notice we're replacing this in the bathroom. If you want a little bit more heat out in your camper and a little bit less in the bathroom because it's a smaller area, you just want to close the door. You simply can regulate how much heat you want in here so you're getting more in the main area of the camper itself.To measure what size you need, you can do this a couple of ways. You can pull your vent out and you can measure the backside here, or if you don't want to pull it out, you can measure from here to here, and from there to there. A lot of times what'll happen is if you measure them here to here, it may give you, this'll say three and a half, and this will say seven and a half.

You want to round up, so you would actually, if this is three and a half, you'd round up to four. If this is seven and a half, you'd round up to eight, and that would be the size vent you would need.The lever to move our vents is very easy to use, very simple to use. You can see it doesn't stick up very far, so we're not going to have to worry about damaging it if it does get stepped on. In my professional opinion, I really like these, I like the metal construction. The powder coat finish on them is going to be really durable.

And if I'm going to replace them in mine, I would go with the dampered ones over the un-dampered because I like the idea of being able to regulate airflow in a certain area if I'm not going to be in there much, and I want more in an area where I'm going to be all the time. That's going to do it for our look at floor registers from JR Products.