SeaSucker Vacuum Mount - 4-1/2" - Black

Video Transcript for Review of SeaSucker Marine Boat Accessories - 302-1101

Hello everybody, this is Jeff at etrailer.com. Today we're gonna take a look at the SeaSucker four and a half inch diameter black vacuum mount. Now this four and a half inch diameter vacuum cup, this'll let you mount or hang a variety of objects to your non-porous, either horizontal or vertical surfaces, and there's no tools required. Basically, you can attach this or remove it in seconds, uses this pump action vacuum here, which creates a nice 120 pounds of pull strain without drilling any holes or damaging the surface that you're gonna attach it to. And just to demonstrate that, I wanted to show you. Now, I have a non-porous material right here.

The table itself is porous, so it wouldn't work on that. So I have this piece of porous or non-porous material just to demonstrate this on. So basically what you'll do is just put this onto the surface, and again, it can be horizontal like this, or vertical. Basically just put a little pressure down on this and then just start pumping the plunger. And as you're pumping that plunger, you'll notice that orange stripe that's on the plunger slowly disappears.

Once you pump it enough, that orange is gone and it's given you the strength you need 120 pounds, we mentioned, of pull strength and it's attached. And again, it'll even work vertically. And then to remove it, it's very simple, on both sides, you have one here and one here, a little tab, you just pull up on that tab and it releases it. So it makes it very easy to attach and you will move it very quickly. If you notice on the top, it has these slotted holes.

This will let you hang or bolt of variety of objects to it. And in the very middle, there's an actual half inch by 20 size stainless steel insert that'll let you attach other SeaSucker products to this unit. It is a nice hard plastic construction, very lightweight, yet durable. If you notice, they do include this nice protective cap that'll protect the vacuum cup from hardening or cracking. Just basically when you're not using it, just go ahead and put this all the way around on it.

Push it down in there. And once you get it all the way in there, you can see that you can store it and not have to worry about damaging that rubber portion of the vacuum cup. So we mentioned it is a black color, it is made in the USA. Again, the pull strength on this is 120 pounds. The diameter, we take our cap off, and we'll put a ruler on it just to show you, is gonna be right at four and a half inches. And the weight on this part is only about a half a pound. But that should do it for the review on this Sea Sucker four and a half inch diameter black vacuum mount.