Replacement Black Switch Housing For Lippert High-Speed Power Stabilizer Jack

Video Transcript for Review of Lippert Components Replacement - Camper Jack Switch Housing - LC258403

So we're taking a quick look at the Replacement Black Switch Housing for Lippert Components High Speed Power Stabilizer Jack. So this is just a little door that's going to house that switch where you can actually operate your stabilizers from. Zoom out a little bit here, you can see that altogether. So our inside measurement is about four inches long by about two and three quarter. It's about an inch and a quarter deep. The mounting holes on the outside there, are about three and three quarter inches apart, side-to-side there.

And then it kind of offset a little bit going diagonally, and those are about two and a half inches apart center to center.The space at the bottom where our switch actually goes through, that is about seven-eighths of an inch wide by about an inch and a quarter long. And then overall, our housing is about five inches wide by about six and a quarter inches long, and top to bottom, about an inch and a half deep. It does come with just that one black housing, no hardware included with this. You will have to pick up some on your own. The diameter of all those mounting holes is about an eighth of an inch.

And this does go with the stabilizer jack from Lippert Components. That part number here at etrailer.com is LC298707. And that's going to do it for our look at the Replacement Black Switch Housing for Lippert Components High Speed Power Stabilizer Jack..