Custom Third Brake Light Camera for Aftermarket Monitor - Night Vision

GCH Automotive Accessories and Parts - GCH94FR

Custom bezel with built-in night vision camera mounts behind your existing third brake light. Line up your fifth wheel or gooseneck trailer using your vehicle's aftermarket monitor (sold separately). Includes bezel, camera, and wiring.

Features:

• Custom bezel with camera mounts behind your third brake light so you can see into your truck bed
  • Works with your aftermarket monitor (sold separately)
  • Assists in connecting fifth wheel or gooseneck trailers
  • Compatible with an RCA composite input
  • Only functions while in reverse
• Camera manually adjusts 360-degrees for a perfect angle into your truck bed
  • Gives you a 150-degree viewing angle
• Rear assist marker lines generated by camera show distance from other objects
• 0 Lux night vision produces a quality picture in complete darkness without IR transmitters
• Waterproof, aluminum camera resists dust and corrosion
  • IP69-rated to protect against dust and close-range, high-pressure spray downs
• Simple installation - no drilling required
  • Mounts with existing hardware

Specs:

• Application: 2019 - 2021 Ram 1500, 2500, 3500, 4500, and 5500
• Camera diameter: 1-1/2"
• Resolution: 620 lines
• Voltage: 12V - 24V DC
• Wiring harness: 24' long
• 3-Year limited warranty

Rear Assist Lines

The rear assist lines generated by the system's camera make connecting your fifth wheel camper or gooseneck trailer a one-person job. The lines appear on your aftermarket monitor (sold separately) and show the distance from other objects, allowing you to accurately line up your connection point when hooking up your camper or trailer.

0 Lux Night Vision

0 Lux night vision produces a quality picture and gives you the flexibility you need when hooking up your camper or trailer. You can line up your connection point in low-light conditions at dusk, or in complete darkness at night without the aid of IR transmitters.

Simple Installation

Simply unscrew and unplug your factory third brake light. Once removed, set your new custom bezel with camera in place. Feed the 6' camera wire through the opening into your truck and re-install your factory third brake light in front of the custom bezel.

Next, connect your 6' camera wire to the 18' wiring harness. This combined 24' wire will extend through your head liner or door sill panel along the edge of the floor, up to the front of your truck, and connect with the included ground and power wiring harness. The power wire will run to your truck's battery.

19RAMBRK360-1 Truck Bed Camera for Aftermarket Monitor - Night Vision