Replacement Trunnion Spring Bar for Fastway e2 Weight Distribution Systems - 600 lbs TW

See what our Experts say about this Fastway Accessories and Parts

• Will the Fastway e2 600 Lb Spring Bars Work With Fastway e2 450 lb System
  Yes, the Replacement Trunnion Spring Bar for Fastway e2 Weight Distribution Systems part # FA92-02-0699 which are rated for 600 lbs will work with the Fastway e2 Weight Distribution System part # FA92-00-0450 which is rated for 450 lbs.
  view full answer...
• Calculating Weight Distribution Tongue Weight and Trailer Weight Capacities
  The weight of the Trunnion Spring Bar # FA92-02-0699(13lbs) does need to be considered for the over weight of the trailer and maximum payload but is not used in the calculation of the tongue weight rating for the Fastway e2 Weight Distribution # FA92-00-0600. So if your 2019 Jeep Grand Cherokee is only capable of towing 6,000lbs the weight of the Fastway e2(94lbs) does need to be considered as additional weight for the trailer as it is weight placed into the receiver. The weight does not...
  view full answer...
• Does The Weight of The Fastway e2 Weight Distribution Spring Bars Count Towards The Trailer Weight?
  With the Fastway e2 Weight Distribution # FA92-00-0600 the Trunnion Spring Bar # FA92-02-0699 weight of 13lbs is shared by both the vehicle and trailer since the weight is sits on the hanger as well as in the hitch.
  view full answer...
• Can Fastway e2 Spring Bars Be Swapped for Different Trailers
  Yes, you can replace the arms on your 10k system so it has the same rating as the # FA92-00-0600. The correct replacement bars are the # FA92-02-0699. This will give your Fastway e2 a tongue weight rating of 250 lbs - 600 lbs so make sure the tongue weight of your loaded setup falls into that range. If a range of 400 lbs - 800 lbs would be more appropriate you can use the arms from the 8k system # FA92-02-0899.
  view full answer...
• Can 1,000 lb Tongue Weight Fastway E2 Round Spring Bar Be Replaced with 600 lb Tongue Weight
  If you wanted to change your weight distribution system to lower the tongue weight range from 1,000 to 600 you would just need to replace your bars with the part # FA94-02-069 if you have the round bar setup or the part # FA92-02-0699 and # FA92-02-0644 for if you have the trunnions. These bars will fit the head of your system.
  view full answer...
• Correct Fastway e2 Weight Distribution w/ 2-Point Sway Control for a Lance 1475 Trailer
  The correct Fastway e2 Weight Distribution w/ 2-Point Sway Control for a Lance 1475 Trailer is part # FA94-00-0600 for round or part # FA92-00-0600 for trunnion. The trunnion spring bars are needed for vehicles which sit lower to the ground. The systems are both rated for up to 6,000 lbs. If you have a higher rated system, it will be too stiff and create an uncomfortable ride. The correct spring bars can be added if you have a different version using part # FA94-02-0699 for round or part...
  view full answer...
• Recommended Weight Distribution Hitch System For a 7X14 Enclosed Trailer 7,000LBS GVWR
  I recommend using the Fastway e2 Weight Distribution # FA92-00-0800 for your 7x14 Interstate Loadrunner tandem axle trailer. This hitch is rated for trailers up to 8,000lbs with a tongue weight between 400-800lbs. If your unloaded tongue weight is lower than 400lbs you can swap the bars for 2 of the 600LB Trunnion Bars # FA92-02-0699. These are rated for a tongue weight of 250-600lbs. The e2 hitch incorporates sway prevention in the hitch. This is very important especially with an unloaded...
  view full answer...

Do you have a question about this Accessories and Part?