Nissan Cube Vehicle Air Mattress

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you don't have to worry about the water damaging wires like you would with electric brakes. That being said, if you use a heat shrink…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

The Rhino-Rack Batwing Awning #RR33100 has 4 segments that come off of the vehicle that are 98" long, and has a 118 sq ft coverage.

Hey Jeff, the WeatherTech ImpactLiner Custom Truck Bed Mat #WT99KF would get secured to your bed using the TechHold Retention Device (see image attached) which is just a adhesive ball and socket. Basically, one the ball end would get stuck to the…

Since your 2024 Telluride X-Line is not an LS or S model the correct wiring harness is the Curt #C29ZV. This will plug into the connection points in the rear cargo area and provide you with a 4-way to power your trailer's signal lights.…

Since the AirBedz XUV Air Mattress #Item #341031 has wheel well cut outs you wouldn't be able to use a fitted sheet. You'd instead need to use a non-fitted sheet or even just a blanket. The dimensions of the mattress are…

Yes, we have either the Anti-Rattle Pin #C69HR or Locking Anti-Rattle Pin #63232 which you can use with the Curt Hitch Extender #C76DR.

The Adco SFS AquaShed RV Cover #290-12230 is going to be the best fitting cover for your 2023 Ford Transit with the medium roof and the 19-1/2' overall length. The Classic Accessories #CA80104 you found is for vans at least…

The B&W Continuum #BW78FR and the Reese Strait-Line #RP66083 are both great systems. The B&W Continuum is going to be easier to set up, but as far as sway control goes, I definitely have to give the edge to the Reese…

No, the Tekonsha OEM Replacement Vehicle Wiring Harness w Brake Controller Adapter #TK74CR will unfortunately not work with your 2023 Kia Telluride with LED lights. Your best bet would be to use a universal wiring harness #C59236 which will work…

I do have a solution for your 2024 Kia Telluride that has the LED taillights that does allow it to have both a 4-way and 7-way plus install a brake controller but it is not with the #TK74CR which does not work for you based on the LED taillights.…