Yates Boat Trailer Keel Roller Review Video

The answer to your question will depend on what purpose the roller is serving. If the roller is being used to guide the boat into place on the trailer, then you'll want it to be able to roll. If the roller is simply providing support, holding the…

For starters, in order to use the CE Smith Self Centering Keel Roller for Boat Trailers part #CE29505 on your boat trailer you will also need to use the CE Smith Panel Bracket for 12" Boat Trailer Rollers part #CE10305G and the Roller Shaft with…

Since you have an older trailer, the brakes could have possibly been switched from electric to hydraulic or the other way around. Even on newer campers, unless it is just purchased from the manufacturer, it would be just a guessing game for someone…

The 10 inch keel rollers from Yates Rubber, like part #YR10000 have a bushing on either end and a metal tube in the middle that acts like a bushing. The #811 simply has the plastic caps at each end. I'd recommend the #YR1000B from Yates. The…

The Roller Shaft with Pal Nuts for Boat Trailer Rollers part #CE10727A which has a 13" long x 5/8" diameter shaft should allow you to add bow bells to an 8" long keel rollers. I don't have an exact length you will need as it…

I went out to the warehouse and measured a few of the Yates Side Guide Rollers #YR12243-5. They were 11-7/8 inches long so they will work great for a 12 inch bracket such as #408300. Both the roller and bracket take a 5/8 inch diameter shaft such as…

Since the red light comes on with your Hopkins Engager Push-To-Test Trailer Breakaway Kit w/ Built-In Charger #20099 it means the battery does not have the proper charge, and thankfully this is very easy to remedy. All you have to do, as evidenced by…

The center to center distance between the mounting slots of the CE Smith Deep V Keel Roller Assembly #CE10401G is 3 inches.

Yes, for a replacement roller shaft with pal nuts to use with the roller part #DL21728 that you referenced you'd want the part #CE10727A which is a 13 inch roller shaft that is 5/8 inch in diameter and comes with pal nuts.

The threaded portion of the bolts of the #K71-403-00 are 7/16 inch but the stepped up diameter is 9/16 inch. The shackle length is 3-1/8 inch from hole center to hole center. The bolt length is 2-7/8 inches. We can't help much with the axle…

Okay, we definitely have a solution for you here, and I'll start with the clearance; with trailer tires you need to have 3" of clearance from the top of the tire to your fender and at least 1" of clearance between the inside of the tire…

The difference between the Yates Keel Roller for Boat Trailers #YR8244-105EC and #YR8000 is that the former has the middle spacing at about 5/8" while the latter has an increased middle spacing of about 1". I have attached photos of each…