Reese Towpower Ball Mount Tow and Go Hitch Step Review Video

The Erickson Big Bed Load Extender, #EM07600, measures 49-1/2 inches from the hitch pin hole to the outer edge of the upright. I have included a picture to illustrate this measurement. To determine exactly how far the extender, #EM07600, will extend…

According to my Erickson representative, their Big Bed Load Extender, part #EM07600 is 48-3/4 inches long, measured from the hitch pin hole to the rear surface of the upright, as shown in the provided photo. If you click the provided link, you can…

The 400 lb limit would be for bed distributed loads. Basically, if what you are carrying weighs less than 400 lbs the Erickson Big Bed Load Extender #EM07600 that you referenced would work for you. Check out the review video I attached for this…

The Erickson Big Bed Load Extender #EM07600 has crossbars which are 48-1/2" when in use, and that dimension does not include the wings - or tie-down points - at the end of the crossbars. The 48-1/2" is usable space, so your 4' wide…

I spoke to a tech over at Curt and they confirmed the ball platform on their #C24WR is right at an inch thick. If you were looking for a ball to go with this, the Brophy #EH68C-C will be an 8,000 pound 2 inch ball option, and the Curt #C40007 will be…

You can have a 2-5/16 inch hitch ball on either a 1 inch or 1-1/4 inch shank. The nut on a hitch ball with a 1-1/4 inch shank takes a wrench with a 1-7/8 inch socket. A hitch ball with a 1 inch shank will take a wrench with a 1-1/2 inch socket. You…

We do have the type of trailer wiring tester you are looking for with the Hopkins Tow Doctor part #HM50928. You can plug a trailer 7-way into this and it will simulate a tow vehicle to let you know if all of the wiring is good.

The Tow Doctor for the trailer side is #HM50928. The other one, #HM50918, is the vehicle side. For the trailer side model it does not work if the trailer has LED lights. LED lights draw too little power for the tester to work properly. You could test…

You can tow a trailer with a weight distribution setup that does not have the spring bars connected. As long as the head of the system is attached to the shank properly (there's no reason it wouldn't be) it would work just as well as a…

In regards to the B&W Tow & Stow 3-Ball Mount part #BWTS10048B for 5" or part #BWTS10049B for 7", the distance from the top of the shank to the bottom of the upright while the hitch balls are stowed away is 8.5" for the 5"…

Most trailer hitch balls have a flat part on two sides of the base like the 2" Hitch Ball - 1-1/4" Diameter x 2-5/8" Long Shank - Chrome - 10,000 #A-90 for example. You will simply need a open end wrench large enough to fit that. Vise…

I do have options for you but we do not have an all inclusive tester kit that will test flat and round trailer connectors on both the trailer and vehicle. Instead you will want to use part #HM50928 for the trailer end and part #HM50918 for the…