LaSalle Bristol ThermaHeat RV Holding Tank or Step Heater Pad Review Video

The 18-1/4" x 12" Holding Tank Heater Pad #277-000164 that you referenced would work well for your 30 gallon fresh water tank as it is designed for 29-40 gallon tanks. The heater is powerful enough that it would not need to make contact…

So long as you have the needed 8-1/2 foot length across the back of your toy hauler, if you'd like you can install the Thule HideAway Awning - Direct Mount #TH490018. You'll need to be able to access the area behind the top rail where the…

The only tank that actually requires a heating pad is the freshwater one because the other tanks you can simply pour RV antifreeze into and not have to worry about heating the tanks. That said if you wanted to you could install Thermaheat pads like…

The gauge wire used on the 18-1/4" x 12" Holding Tank Heater Pad #277-000164 that you referenced is 14 gauge.

The ThermaHeat RV Holding Tank Heater Pad, Item #277-000164, will need to be connected to a 12 volt power source. You should be good to go and you just need to follow the installation instructions for safety and security. I have attached a short…

The ThermaHeat RV Holding Tank or Step Heater Pad part #277-000163 do get hot to the touch but not enough to burn you as they has a 67 degree cutoff. The outside of the pad should not exceed the shutout off temp although there are a few factors to…

I have everything you need to setup and flat tow a 2021 Ford Bronco with Heavy Duty Modular Bumper. The first thing you'll need is a base plate kit, the Roadmaster Direct-Connect Base Plate Kit part #RM92ZR is designed for this exact bumper so…

The ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat #277-000163 that you referenced does radiate heat on both sides of the pad. When the ambient temperature drops below 45 degrees the heater comes on and won't go off until it has…

The differences between the Valterra #T80, #T80C, and #T80A simply has to do with the types of connections that they have. They vary between Hub (female) and Spigot (male) ends to suit your needs. The ends that change are on the side. The top of each…

I went out to the warehouse to look at the two extension tubes included in the Valterra Waste Valve Extension Rod Kit #T1046-12VP referenced in your question. The rods are threaded all the way through on the inside, so while they were not designed…

The difference between the three Valterra Double RV Waste Valves referenced in your question has to do with their fittings, specifically their use of hubs or spigots. Basically a spigot (also referred to as the "male" fitting) will go…

I spoke with my contact at Therma Heat regarding the Heater Pad with Thermostat #277-000163 referenced in your question. She stated that it is perfectly safe to install an insulating blanket over the heating pad. Please note though, that in order for…