etrailer Round Pipe Mount Swivel Jack with Footplate Review Video

I went out into our warehouse and measured a Pro Series Round, Pipe-Mount Swivel Jack #PS1401080303 and found that it is 26-1/2 inches from the top of the jack to the bottom of the footplate. And then it is 35 inches if you spin the jack handle…

I recommend using the CE Smith U-Bolt Kit #CE23002 to mount the Dexter 3,500lb axle under your 2020 Grand Design Imagine travel trailer. This kit uses zinc coated u-bolts, nuts and washers while the mounting plate is galvanized to increase life of…

The U-bolts of the U-Bolt Kit part #APUBR-1 are Grade 5. The torque range is minimum of 45 ft lbs and a maximum of 70 ft lbs. I attached an install and review video for this kit for you to check out as well.

The TruRyde Bearing Kit #BK2-100 that you referenced comes with an inner bearing and race, an outer bearing and race, cotter pin, tang washer and one inner grease seal, a double lip #10-19. If there was actually an extra component in your kit it is…

The 2-3/8" measurement you are referring to on the CE Smith U-Bolt Kit part #CE23002 is in regards to the diameter of trailer axle that the kit is designed to be used with. The actual width of the u-bolt from the inside edge of each bolt is…

If your springs are already on top of your axles as it sounds, then you will lose the diameter or your axle plus the spring stack height when you flip the springs to the traditional location under the axle. This will most likely lower your trailer by…

For a 3500-lb axle, it's most likely a 2-3/8" diameter so you can use the U-Bolt Kit for Mounting 3,500-lb, Round Trailer Axles - 5-1/2" Long U-Bolts #APUBR-1. If this is a boat trailer or utility trailer that might be sitting outside a…

I did some looking and found that the 46210 and 46845 hubs you currently have use the same #L68149 inner bearing and #L44649 outer bearing. However, as we do not carry the Tie Down Engineering Vortex hubs, I cannot say what all will fit them,…

This Bulldog Round, Snap-Ring Swivel Jack #BD151101 is a weld on jack. You will need to remove the mounting bracket from this unit and have it welded to the frame of your trailer near the coupler and then reinstall the rest of the jack on to the…

There are some Dutton-Lainson trailer jacks that are made in the USA as well as a few that are not. Any jacks that we carry that are made in the USA have that as part of the description to help set them apart. Currently we have the following options:…

The GloLight LED Trailer Tail Light #STL178RB will not work with the Snap-on Reflector Ring for STL78RB Series LED Lights #A78RXB as it will not fit the light. If you wanted to use that reflector ring you would need the Optronics LED Trailer Tail…

Your Yakima FullTilt features a SpeedKnob that tightens the rack inside your hitch to reduce noise and movement. Based on your photo, it looks like the anti rattle device on the adapter is slightly expanded, preventing it from going into your 2 inch…