Camco Trailer Tongue Jack Stand Review Video

The best way I can think of to lock the Camco #CAM55312 Power Defender would be to use a cable lock like #8122D. If you can pass a few wraps of the cable through the handle of the male plug and get the cable tight enough that it can't be…

The wire gauge used in assemblies like the part #AKEBRK-7R-D is surprisingly thin at 16 gauge. The heavier gauge the wire the better. We recommend 10 gauge wire like part #10-1-1 (sold by the foot), for wiring up the brake output circuit. Since the…

The overall width of the Camco Olympian 5500 Grille #CAM57305 is 22 inches.

Weight distribution shanks are most of the time interchangeable between manufacturers, so if you need a specific drop or are simply looking for the best price you can use any shank that fits your trailer hitch receiver and meets the tongue weight…

This is a really great question, but the weight of the weight distribution system actually does not count as additional tongue weight. We've asked our WD system manufacturers and they'd told us that the WD system basically becomes a part of…

Yes, weight distribution shanks are standardized/universal so you can use one from an old system on the Strait-Line Weight Distribution Systems like part #RP66073.

Yes, the Firestone Ride-Rite Air Helper Springs part #F2407 will work on a 2017 Toyota Tacoma so long as the axle is below the leaf springs. That said, you'd also need the Firestone Axle Bracket Extension Kit for Lifted Vehicles part #F2506 to…

For a Reese Strait Line system with the tongue weight range and trunnion bar setup you'd want the part #RP66083 which has the range of 400-800 lbs. Then for a 2-5/16 inch ball you'd want the #19286 and you'd be set.

Yes that's correct! As long as the load is evenly distributed the Mount-n-Lock SafetyStruts Standard RV Bumper Support Brackets #MO22FR will accommodate up to 400lbs, and will fit bumpers that are 4" to 4-1/2". Additionally, bumper…

Yes, the Camco Trailer Tongue Jack Stand #CAM44635 can be used on your trailer with 760lbs of tongue weight. The stand itself is rated for up to 5,000lbs of vertical load. You might consider the Fastway Flip Automatic Fold-Up Jack Foot with a 4"…

Valterra makes the similar jack stand #A10-0900. This one is rated for 10,000 pounds. I have linked a video review of this stand for you.

MORryde has a version of the X-Factor Crossmember that was designed to work with the CRE3000 you have with the part #MR33WR.