Trailer Brake Controller Installation - 2002 Chevrolet Silverado 3025-P Video

It sounds like you may have one of 2 things going on inside your wet bolts. I have seen some instances where some particles/dirt get inside the wet bolt and clog the weep hole the grease is allowed to pass through. You can remove the bolts not…

The P3 part #90195 is basically the nicest brake controller on the market and we recommend it highly. This is our best selling brake controller because of how well it works and how easy it is to setup. This is a proportional brake controller that…

If the brake light indicator of the Draw-Tite Activator Trailer Brake Controller #5504 is on all the time that would indicate that the brake light circuit (red wire) could be shorted out to the power wire (black) of the controller and because of that…

I am guessing that either your trailer connector is wired incorrectly or there is a problem with your brake controller. The only pin on the connector that should show constant voltage is the 12-volt accessory circuit. The pin for the brake output…

Based on what you have said here the brake controller is faulty and it will need to be replaced. There should not be power output on the blue wire behind the controller all the time. This indicates a problem with the internal circuitry of the brake…

The troubleshooting guide for the (discontinued) Draw-Tite Activator II 5500 is actually the same as the Draw-Tite Activator IV #5504. The instructions (with the troubleshooting guide) for the Activator IV are linked for you to reference but I have…

Yes you can use the Ball Mount Adapter for Convert-A-Ball Cushioned Weight Distribution Shank #BA-1 with your Curt Adjustable 2-Ball Mount #C99NR as they have the same 1-1/4" hole spacing and use the same 3/4" adjustment pins.

There are a few options for in-bed wiring for your 2002 Chevy Silverado. I recommend a 90 degree harness like #50-97-410 because it is easier to get it to fit in the truck. You could also use #C56000.

Since suspension components use lock nuts on the ends of the shackle bolts and the bolts need to be able to allow movement you actually don't want to torque down the bolts at all. You want to snug them up so that there's no lateral play but…

I can help you figure out how to determine the best option for a wet bolt/shackle upgrade kit, though in order to determine the correct one you will need to take a quick measurement of the shackle straps on your Jayco Jay Flight. The reason for that…

As long as your tongue weight does not exceed 2,000 lbs the Blue Ox SwayPro part #BXW2001 would be perfect for you as it has a 2,000 lb tongue weight rating and uses frame brackets that clamp to the the trailer frame. For a hitch ball you would want…

If you check out the picture I attached you can see that the hitch opening for the Curt #C15302 that you referenced tucks right up under the rear bumpers so it would give you the exact same ground clearance as your current hitch. Which means your…