Pro Series Solo Hitch Cargo Carrier Review - 2015 Mazda CX-5 Video

Yes, you can use a swing away adapter such as the Kuat Pivot 2 Swing Away Hitch Extender part #PVP20B or part #PVD20B with a cargo carrier. That said, you will need to abide by the weight capacity which is 250 lbs or 50% of the trailer hitches…

You are correct, if you were to extend the length of your trailer tongue it would not lower the capacity of the tongue weight of your hitch. If anything the hitch has more leverage over the tongue weight now like you mentioned so the opposite would…

The Pro Series Cargo Carrier you mentioned, part #PS1040100 offers 12 inches of clearance between the pin hole and closest portion of the basket portion of the carrier. The distance between the hitch pin hole and the bend in the shank is 5 inches,…

One simple measurement will tell you if this ProSeries Cargo Carrier #63153 will clear the back bumper of your 2011 Toyota 4Runner. If you measure from the center of the hitch pin hole on the side of your receiver tube to the rear-most part of the…

The Pro Series Hitch Cargo Carrier, item #PS1040100, should fit nicely in the 2 inch hitch on your 2010 Jeep Patriot. The shank on the carrier measures 12 inches from the center of the hitch pin hole to the raised side of the platform and raises 4…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…