Front Mount Trailer Hitch Installation - 2002 Ford F-250 - Curt Video

The SuperSprings #SSA22 would be a smart choice to raise your 2012 Ford F-250 when pulling your fifth wheel. They are designed to prevent the sagging you are experiencing and should put you pretty close to level. If you take a look at the attached…

With the Equal-i-zer Weight Distribution System #EQ37100ET installed on your 2020 Ford F-250 you will not need anything else to remove the sag from the trailer. The head of the Equal-i-zer hitch needs to be adjusted to redistribute more weight on the…

Since the Firestone Ride-Rite Air Helper Springs - Double Convoluted - Rear Axle #F35FV and the helper springs like the #SSR-127-54 install at the same spot you will only be able to install one of them on your 2019 Ford F-250 4WD, but you will also…

The correct replacement for your MaxxAir Circuit Board 10-04751ks is the following part: - Replacement Printed Circuit Board for MaxxAir MaxxFan Plus Roof Vents #MA10A04751KS As for the sensor wires, so long other wires are not damaged, I don't…

If you do not have the blocker bar or sub-bumper behind the air dam, the Draw-Tite #65022 would a good choice for your 2000 F250. According to the installation instructions, the tow hooks are temporarily removed but are re-installed later in the…

I'd be happy to help you with that. Since it's a tractor, there's likely a few differences from what would be seen on a standard passenger vehicle. You very likely won't need to contend with turn signals and taillilghts, and you…

The air bag kit I recommend installing on your 2005 Ford Excursion is the Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers #AL88340 which are rated to help out with up to 5,000 lbs of cargo (this won't increase…

The Hollywood Racks Sport Rider SE Bike Rack part #HLY84FR is an excellent bike rack option with 80 lb per bike weight capacity. It has a lifetime warranty and comes with locks for both the bikes and racks.

The front mount trailer hitch I recommend for your 2005 Ford F-350 is the Curt Front Mount Trailer Hitch Receiver part #31114 because it is made in the USA and currently our most cost effective option for a front mount hitch. I called Curt and they…

I'd be happy to. As you can see from the cutout I added from the instructions, the leaf spring brackets from the Curt #C31014 are necessary in order to install this front-mounted hitch on your 2002 Ford Super Duty if it has a blocker bar. You can…

The difference between the Curt Hitch #C31014 and Curt Hitch #31114 is that the #C31014 is designed for vehicles with blocker beams and the #31114 is designed for vehicles without the blocker beam. You will want to look under the front end of your…

On a 2000 Ford F-250 or F-350 you will measure from the rear edge of the truck bed (not the tailgate) forward 48-1/4 inches to drill the hole for the gooseneck ball when installing Curt hitch #C60720. I have included links to the 2 sets of…