Blue Ox Base Plate Kit Installation - 2009 Honda CR-V Video

When using Hopkins tow bar wiring harness #HM56300 you can use Roadmaster Fuse Bypass #RM76511 if you do not want to have to pull fuses when towing the car. It is not essential but it will make life easier. Please see the linked installation video.

In order to flat-tow your 2009 Honda CR-V with four wheels downs, which is the recommended way to tow this vehicle according to the owner's manual, you will need base plates, a tow bar, safety cables, a supplemental brake system, a flat-tow…

The distance between the mounting holes from side to side on the Draw Tite trailer hitch part #41945 are 38-1/2 inches. This hitch fits the following vehicles: 2004 - 2014 Ford Van E-150 2004 - 2014 Ford Van E-250 2004 - 2014 Ford Van E-350 2000 -…

If the Draw Tite hitch part #41952 has the correct mounting hole dimensions needed for your 2004 IC CE200 bus then there's no reason it wouldn't fit.

Yes, the front hitch part #65053 that you referenced does fit your 2022 Jayco E-450 chassis RV.

The Draw-Tite Ultra Frame Trailer Hitch Receiver w/ Cast Center #41946 is a confirmed fit for the 1996-2018 Chevy Express and GMC Savana Vans. There is not a confirmed fit for any E450 models, but I did measure the hitch as you requested to see if…

Your weight distribution system, #EQ37120ET, is rated for a total tongue weight of 800-1200 lbs. That total tongue weight is the loaded tongue weight of your trailer as well as any cargo behind the rear axle of your tow vehicle. I've attached an…

There are 5 main parts you will need to flat tow your 2009 Honda CR-V. Those parts are a base plate kit, tow bar, safety chain, tow bar wiring and a supplemental braking system. I have included a list of parts confirmed to fit your 2009 Honda CR-V…

Rather than change the coupler, the easiest option is to change the size of the ball ON YOUR BALL mount. If your coupler currently uses a 1-7/8 inch ball and your towing vehicle has a hitch and ball mount with a 2 inch ball, you can use an…

The torque figure is 180 ft lbs. Sorry for the confusion there. As far as the pin orientation. Convert a ball tested that and determined that having it perpendicular was better. Having it that direction prevents the pin from getting damaged from…

The gain knob of the Blue Ox Patriot #BLU37TR allows you to basically dial in how aggressive/sensitive you want the accelerometer to be. If you dial it in with high gain the unit will apply the brakes harder when detecting braking, lower and it will…

In regards to the Replacement Consumer Lockout Key for Dexter Axle Brake Actuators part #DX94FR, this is only to be used when needing to reverse with the trailer as it will stop fluid from progressing through the cylinder applying the brakes on the…