Tekonsha Custom Fit Vehicle Wiring - Trailer Hitch Wiring - 118427 Review Video

The Draw-Tite trailer hitch receiver, part #75547, uses 4 hex bolts that are M10 X 1.25 X 30. However, you shouldn't tap the threads uness you absolutely have to as a last resort. I highly recommend cleaning them before tapping them.…

The typical tire should run about 158 degrees (Farenheidt) once you get going down the road, but this can vary greatly depending on the weight of the trailer, how fast you're traveling, and also driving habits. So while 158 is probably…

In order to flat-tow your 2009 Honda CR-V with four wheels downs, which is the recommended way to tow this vehicle according to the owner's manual, you will need base plates, a tow bar, safety cables, a supplemental brake system, a flat-tow…

There are 5 main parts you will need to flat tow your 2009 Honda CR-V. Those parts are a base plate kit, tow bar, safety chain, tow bar wiring and a supplemental braking system. I have included a list of parts confirmed to fit your 2009 Honda CR-V…

The connection point is located behind the interior trim panel in the cargo area on the driver side. The 4-pole trailer connector will be stowed inside the cargo area of the vehicle. You will need to open the rear door of the vehicle and temporarily…

For a trailer hitch that fits your 2010 Honda CR-V like the Draw TIte part #75547 the install hardware included is M10X1.25X30 CL8.8. I attached a couple help articles on cleaning weld nuts for you to check out as well.

If all you plan on towing is the boat and trailer then 200 pound tongue weight capacity and 2,000 pound gross trailer weight capacity of the Draw-Tite trailer hitch #24792 that you have referenced would be a good choice. Check the owners manual on…

The Curt fifth wheel rail kit adapter part #C88KR was designed to fit the puck spacing in the bed of your 2022 Chevy Silverado 2500HD so we can guarantee it will fit your truck without requiring you to measure anything to verify. It also provides the…

I checked the parts breakdown in the instructions for Draw-Tite trailer hitch #24792 and it does indicate that two 7/16 inch pull wires are included. I have linked those instructions and a video showing an example installation for you.

There are both Class I and Class III trailer hitches available that are confirmed to fit your 2010 Honda CR-V. The available Class I hitches, such as the Draw-Tite Sport Frame #24792, feature a square tube design, while the Class III hitches like the…

In regards to the Replacement Consumer Lockout Key for Dexter Axle Brake Actuators part #DX94FR, this is only to be used when needing to reverse with the trailer as it will stop fluid from progressing through the cylinder applying the brakes on the…

The Tow Ready T-One Wiring Harness, #118427, will plug into the white trailer tow plug on your 2010 Honda CR-V, located behind the drivers side rear interior trim panel. You will also need to attach the white ground wire on the wiring harness to the…