Trailer Brake Controller Installation - 2000 Chevy Silverado Part 1 Video

The 2000 Chevy C/K Series does not have a plug in the relay box or under the dash to plug a brake controller adapter into. To wire in a brake controller like part #90195 it would be a hardwired application. To accomplish wiring in the brake…

Brake controller wiring Colors are as follows. White = ground, negative battery terminal Blue = trailer brake feed, output to 7-Way trailer connector Red = stop light, 12 volts when brake pedal is pressed Black = 12 volt power, constant If the red…

Yes, I attached an install video that shows the Pollak part #PK12-707E (same as number you mentioned) installed in a newer GMC to this page.

The wiring will already be run on your 2000 Chevy Silverado. There will be 1 of 2 wiring situations on your truck. The wiring for the 7-Way will be located above the spare tire. If it is just bare wires with no plug, you will need to hard wire one…

There are some connections under the hood that will need to be made to complete the installation of the Tekonsha P2 Brake Controller #90885 with Wiring Harness, #3025-P. Once you have plugged in the #3025-P harness into the port to the left of the…

To add a wiring harness to your 1992 Chevy Silverado for your boat trailer you need to first add a 4-flat, the T-One Vehicle Wiring Harness #118315; I've attached a link showing this harness being installed on a similar truck for you to check…

Although we do not have a cover that takes up that whole space, I do have a way that you potentially mount your 7-Way at your rear bumper on your 2010 Chevrolet Silverado. You could use the Mounting Bracket for 7-Way #18138 by disconnecting the 7-Way…

We do have what you need to install a fully functional 7-Way connector on your 1995 GMC Sierra, however there is not a plug and play 7-Way option similar to the 4-Way Harness #118315 available for your truck. If you do not yet have a connector…

The wire you are referring to is probably the center high mount stop light wire or CHMSL. This wire would be used for a third brake light function for example on a camper shell. You can test it by using a circuit tester like #PTW2993. If the wire…

In 1994 the Sierra was just a trim level of the C/K series GM trucks. It wasn't until 1999 that the Sierra started to take the place of the C or K designation and that transition was complete in 2000. For a trailer wiring harness that will fit…

While it looks like you are pretty close to finding the correct port for installing a brake controller in your 2001 Chevy Silverado I attached a picture of where the install harness does plug in using a harness like the part #3025-P. For a brake…

On a 1999 Chevy C3500 there will NOT be a brake controller port to plug in a brake controller. The brake controller has to be hardwired into the truck. Chevy did not start putting in a port until they switched the trucks from C or K to Silverado.…