Install Video for Pollak 12-705 7-Way Trailer Wiring

Question

Question:

i need to replace pollack trailer plug model 12-705 is there vedio with part so i can install

asked by: Frank H

0

Expert Reply:

Yes, I attached an install video that shows the Pollak part # PK12-707E (same as number you mentioned) installed in a newer GMC to this page.

expert reply by: Jameson C

0

Answer 1

To wire in the reverse light wire on Curt 7-Way connector #C57102 for the back up alarm to work you will need to tap into a reverse light wire behind a reverse light on your 1999 Dodge Ram. If you do not wish to tap into the wire there then you can…

view full answer...

Answer 2

The Rubber Lube Plug - Fits 1.18" Lubed Dust Cap #DC-RP is the replacement for the #RG04-040 grease cap as well as larger caps like the 2.44" OD Drive In Grease Cap with Plug #RG04-080. The Grease Cap Plug fro E-Z Lube Grease Caps…

view full answer...

Answer 3

The spindle that is on the Dexter Trailer Idler Axle w/ Idler Hubs #20440I-EZ-60 is a BTR spindle like part #TRU44FR. . The stub diameter (A) on the TruRyde spindle is 1-1/4 inches, The part where the grease seal rides (B) is 1.5 inches. It uses…

view full answer...

Answer 4

Either way is correct. It depends on if you want to keep the semi-style 7-Way (if you need to tow that type of trailer) or if you will never be towing a semi-trailer. If you need to keep the 7-Way semi active on the truck, then you would need to make…

view full answer...

Answer 5

There are a number of factors involved when converting a semi 7-way to an RV 7-way. Semis generally use a 7-pin round pin socket, similar to #PK11720. And RV style 7-way uses blades, like #PK12706. We do not offer any pre-made adapters to make this…

view full answer...

Answer 6

Past customers have told us the AL-KO 8460 uses inner bearing 25580 and outer bearing 15123, which would make the Timken Bearing Kit #TMK82VR the correct replacement bearing kit for that hub. If you are looking to replace the hub entirely the correct…

view full answer...

Answer 7

The 2 easiest ways to tell if your 2020 Toyota Highlander XLE has the factory tow wiring is to either check behind the paneling next to the 3rd row seating on the driver's side to see if a connector is there that the Curt #C79VV module plugs…

view full answer...

Answer 8

To determine if your motorhome has the Tiffin air brake setup or Freightliner BrakeSync you'll need to look at the rear and see if there's an quick disconnect fitting for your air line. The standard Tiffin air coupler fitting would look like…

view full answer...

Answer 9

For a trailer that has an angle iron frame like what you have what I would recommend is a system like the Reese Steadi-Flex part #RP66558 you referenced and have the outer brackets welded to the frame of the trailer since there isn't a clamp on…

view full answer...

Answer 10

On a 7 pin round which is the common connection on a semi trailer, the clearance/marker lights are at the 10 o clock position when you look at the trailer wiring connection. When looking at the connector on the back of the truck, that will put the…

view full answer...

Install Video for Pollak 12-705 7-Way Trailer Wiring

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching