Best 2020 Subaru Crosstrek Trailer Wiring Options Video

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The installation time of the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector part #C59236 will vary by application. That said, the average professional install time I would estimate as two hours.

On the 2010 Subaru Outback the wiring harness is sometimes hard to find. For some reason it gets routed differently and can be in the spare tire well, up along the back near the bottom of the rear seat or under the rear panel nearest the hatch. I…

If you're wanting a 2 inch hitch for your Crosstrek so you can use your existing bike rack, we have 2 options that I would recommend for you. If you don't mind The crossbar of the hitch being visible, the Draw-Tite Class III hitch, part…

I was able to confirm with Draw-Tite that they do have a trailer hitch receiver which is a confirmed fit for your 2019 Subaru Crosstrek hybrid, which is the following hitch: - Draw-Tite Max-Frame Trailer Hitch Receiver #36644

We haven't had any ground clearance issues with any of the trailer hitches we offer for your 2018 Subaru Impreza including the Draw Tite part #36644 that you mentioned. When we installed the 2 inch hitch part #76209 on a 2018 Impreza like yours…

The Draw-Tite Class II #36644 hitch fits the 2018 - 2021 Subaru Crosstrek and the 2018 - 2021 Subaru Impreza 5-Door Wagon with Single Exhaust.

I checked with Draw-Tite and can confirm for you that the Draw-Tite Trailer Hitch #36644 you asked about will fit your 2019 Subaru Crosstrek hybrid. I attached an install video for this for you to check out as well.

Installing a wiring harness, like the Tekonsha T-One Vehicle Wiring Harness #118467, on your 2020 Subaru Crosstrek will require access/removal of a few panels in the rear cargo area. I included an install video for you to check out that will…

The spacers that come with the etrailer hitch that fits your 2022 Subaru Crosstrek are designed to be used as a way to level the hitch as needed. So if using them causes your hitch to not sit level I would recommend removing them.

I took a look in the owners manual of your 2018 Subaru Crosstrek and found that it has a 200lb tongue weight rating, so while the etrailer Trailer Hitch #e98912 has a much higher 525lb tongue weight rating you will still be limited to the lower…

The install of the Curt 2-inch hitch part #C13382 that you referenced on your 2019 Subaru Crosstrek would not negatively affect the crumple zone of the rear bumpers. This attaches to the bottom of the vehicle frame where a hitch was designed to…