Trailer Connector Socket Installation - 2001 Chevrolet Tahoe Video

I do not recommend attempting to pull a 5th wheel with that vehicle. The Avalanche may have adequate towing capacity for smaller 5th wheel campers. My main concern is configuration of the truck bed and that it would not allow turning clearance.…

On the Curt hitch #14080 the rear hole to the receiver face is 14.36 inches. From the frame to the top of the receiver is 1.85 inches.

For a receiver hitch, I'd recommend the Curt Class IV, part #14080 which has a 10000 lb towing/1000 tongue weight capacity or 12000 towing/1200 lb tongue weight capacity if used with a weight distribution system. These capacities would be ideal…

The instructions are referring to the bolt diameter and not the head size for the torque specs of the Curt Trailer Hitch Receiver #14080. The Carriage bolts and nuts are going to be 1/2" diameter while the bolts that thread into the weld nuts on…

I went out to the warehouse and pulled the Waterproof, Under 80 inch LED Trailer Light Kit, item #TLL9RK, to see exactly what Optronics means by waterproof. Upon initial inspection the housing itself is not water tight. Water can access the housing…

Typically the running light circuit will be noticeably dimmer than the brake/turn signal circuit, so what you described could be normal depending on how dim the lights are. Without seeing how dim the lights are it's hard to say for certain. If…

The Optronics stud-mounted LED Trailer Light Kit, part #TLL9RK, features left- and right-hand LED light assemblies that are DOT-approved and waterproof, and includes a 25-foot wiring harness, mounting hardware and connectors, and a license plate…

That depends on the mounting dimensions of your square lights. If you check out the picture I attached you will see the mounting hole dimensions of the part #510-9 that you referenced that you can compare to your taillights.

For PWC you can store them on roller bunks. For boats they do not recommend storing on rollers for a long period of time unless wood blocks are used. Otherwise small indentations or cracks can occur on the hull.

Yes, the light assemblies of the #TLL9RK will fit in the Light Guard #LG440NP. The #LG440NP has inside dimensions of 5 by 5-1/2 inches and the assemblies of the #TLL9RK are 5-3/16" long by 4-3/4" wide so they would fit.

I spoke with my contact at Dutton-Lainson about storing your pontoon boat on the #DL21755 roller bunks. They said there is no problem with storing your boat on the roller bunks over the winter. The bunks have a weight capacity of 3,000 pounds, so as…

There are several things that could cause your trailer light to behave like this. The most likely causes are a bad or weak ground connections or a dirty/corroded trailer connector. Make sure that both the truck and trailer side connectors are clean…