Curt Trailer Hitch Installation - 2012 Chevrolet Tahoe Video

Hey John, so the factory 7-way mounting bracket of a 2012 Chevy Tahoe would have been built into the rear bumper so if that's rusted away what you'd need to do is use a bracket like the part #PK12711U which attaches to the lower rear…

The Curt Class III hitch, part #C13161 is indeed a fit for a 2013 Chevy Tahoe PPV (Police Package Vehicle). You can see it being installed on a 2012 St. Charles County Police PPV Tahoe by clicking the provided link. The tow package harness is…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish tem #e23ZR for your 2020 Toyota RAV4 weighs 38 lbs.

When it comes to installing a trailer hitch on your 2014 Chevrolet Tahoe The Curt Trailer Hitch Receiver - Custom Fit - Class III - 2 inches #C13161 is confirmed to fit all 2wd Tahoes. This trailer has a bolt-on installation with no welding required.…

It is a very good idea to keep spare bearings and seals (and wheel bearing grease too) on hand for the unexpected roadside stop. We have individual bearing and seal parts like #L68149, #L44649 and #58846 as well as kits like #BK2-100 that combine…

We do have carriers like part #C18150 for a trailer hitch but they are designed to be used for cargo. You would need to make sure you secure the propane tank really well so it does not fall or have a chance of falling out of the carrier. Also, you…

The hitch that I recommend for your 2021 Toyota Rav4 to use your bike rack is going to be the etrailer Trailer Hitch Receiver #e23ZR. This hitch is made in the USA, has a bolt-on, no-drill installation and will provide you with a 2" receiver…

The 20 x 59 Curt Cargo Carrier #C18150 that you referenced weighs 55 lbs and has a 500 lb weight capacity.

I would be happy to go over how to figure out which bearings your 2014 Aluma 8113 SR and 2012 6310H BT use, but this is not information we have on hand. To determine the bearings used on each trailer you will need to remove a hub assembly and look…

For your 2010 Chevy Tahoe the only front hitch we have available is the Curt #C31012 which is a confirmed fit. To install the Curt Front Mount Trailer Hitch #C31012 that you referenced you will need to either remove the lower fascia or trim it. Check…

If your 2005 Chevy Tahoe did not come with a factory installed 7-Way trailer connector then you will need to add one using #30955 which plugs into a connector located above the spare tire under the vehicle. I have included a picture that shows what…