Review of etrailer Trailer Fenders - Single Axle Jeep Style Fender - HP99VR Video

It looks like the Harbor Freight Folding Trailers use a Jeep style fender so if that's the case then the best option we have for replacement is the Single Axle Trailer Fender part #HP99VR which will work just fine with 4.80x12 tires. That said,…

You have 12 inch rims, but extra 3/4 of an inch you measured is for the lip of the tire that does not count towards the overall diameter. The black fenders part #F008559 should work well for you, but to utilize your current mounting setup you would…

We carry lots of trailer fenders. I have included a link to them for you. Personally I think the best place to get anything is right here at etrailer. Of course I am a little biased. If you can tell me the wheel size that you have I will be happy to…

Trailer tires and wheels do not typically come balanced from the factory like what you see with standard passenger vehicle tires. This isn't usually needed for trailer tires and most car shops don't have the needed setup to properly balance…

What you found is a DOT number and not a speed rating. I was able to figure out which tire you have and it's a Loadstar 4.80-12 that has a 65 mph speed rating. In this size we have a tire that can go 81 mph as part #TT48012C.

For your rim that has a 4.80x8 tire installed on it you could go up to the 5.70-8 size tire like the part #AM10012. This tire will be 2 inches taller in overall diameter.

Trailer hubs that a 8 inch wheel can also fit a 12 wheel so yes you could upgrade to the larger wheel size. So you could use a 5.30-12 tire and wheel like the part #AM30780. The pilot diameter would be large enough to fit over the hub pilot. Since…

There is a diameter difference of approximately 1 inch between our 5.30-12 trailer tires and 4.80-12 trailer tires. Our 5.30-12 tire have an outer diameter of 21.9 inches. Our load range C 4.80-12 trailer tire has an outer diameter of 20.7 inches and…

You will need to measure the diameter of the spindles where the seal and bearings ride. Check out the picture I attached that shows where this is. You will need an exact measurement so either a digital or dial caliper will be needed. To pick out the…

Great question. As a general rule, when your trailer is loaded to it's full capacity, there should be a minimum clearance of 3 inches between the top of your tire and the underside of your fender.This should give you adequate clearance for…

I have a replacement option for you, but the only slipper spring we offer that is 1-3/4" wide and is 26-1/4" long is the 4-Leaf Slipper Spring w/ Open Eye End for 4,300-lb Trailer Axles - 26-1/4" Long #e33SR. Since you mentioned that…

Sounds like your trailer has slipper springs and you are wanting to convert it to a double-eye system. This is definitely possible. It would be just a matter of changing springs and hangers. You would need to go with a leaf spring that is rated for…