Valterra RV Sewer - Waste Valves - T38C Review Video

Thanks for the picture of what you have based on that you are in need of the Double RV Waste Valves - Sewer Wye #T38C.

The difference between the part numbers you mentioned of #TR38, #TR38A and #TR38B comes down to the difference between spigots and hubs in terms of how these valves install. So hubs fit OVER a pipe and spigots fit INTO a pipe. So the part #TR38A has…

I went out to the warehouse to take a measurement of the 3" diameter pipe on the Double RV Waste Valves #T38C and found that without the cap it measured 5" in length, as you can see in the accompanying photo I've added for you. I have…

The Double RV Waste Valves #T18A has the following dimensions: From the edge of the 3" hub to the bayonet: 7" From the 3" hub flange to the bayonet: 5-1/2" From the edge of the 3" hub to the center line of the 1-1/2"…

The difference between these models is the connection points for the black and gray water pipes. A hub will fit over a pipe while a spigot will fit inside of a pipe. You'll just need to choose the correct connection type for your current piping.…

As long as the SuperLube spindles on your trailer use the #L68149 inner bearing and #L44649 outer bearing, the etrailer E-Z Lube Trailer Hub and Drum Assembly #AKHD-545-35-EZ-K will work perfectly. The only thing different about the SuperLube…

The valves you are seeking to replace are made by many different manufacturers and are a standard size. The function of the valve is what you want to pay attention to as there are T-handle and cable options and then of course black water versus gray…

The Double RV Waste Valves #T18A has a 1-1/2" spigot so you'd have to also pick up a coupling #344633001 in order to attach it to the existing pipe. Instead I recommend the Double RV Waste Valves #T18, which comes with hub fittings so you…

No, the Bristol Double RV Waste Valves #34466ND13AAR would not match what you have pictured, but you would be able to swap out what you have with the Double RV Waste Valves #T38C.

You should be able to tell which Valterra Double RV Waste Valves you need by inspecting your current connection points. The one end with the lugs on it is the same on all 3 parts so you simply need to determine if you need hubs, spigots, or a…

From the picture you provided, it does look like the Double RV Waste Valves - Sewer Wye - Rotating - 3" Spigot and 1-1/2" Spigot #TR38B will be the correct fit for you. However, I will say it is a good idea to measure the 2 pipes going into…

To replace your current double waste valve you'll just need the Double RV Waste Valves - Heel Inlet - Rotating - 3" Hub and 1-1/2" Hub #T68 and some Valterra ABS Solvent Cement - 1/4 Pint #A05-0303 for a secure connection.