TruRyde Trailer Suspension - Leaf Spring Suspension - TREQ356 Review Video

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

I attached a picture that shows the proper position of shackles and equalizers on trailer suspension. Sometimes the shackle will flip up but if you jack up the trailer by the axle that's got the shackle flipped you can usually get it to flip back…

It really just depends on what you are looking to get out of the bushings. Bronze bushings, like part #K71-291-00, will last longer but are more noisy and it is recommended to use wet bolts like part #126B2 to keep them lubricated. Nylon bushings,…

When changing the size of the equalizer that is on a trailer, this will affect the size of hangers needed or the spacing of the hangers. For example, if you were to go with an equalizer that is one inch taller, you could keep the center hanger the…

You can use wet bolts with nylon bushings or bronze bushings. It does not matter which material the bushings are. Also nylon and bronze bushings have about the same longevity.

A Moly EP grease like part #LM54FR would work well for greasing the suspension components of your trailer. For a grease gun to use the wet bolts and get grease into the #trbu11566 with the wet bolts you would want the #L30200. As long as the wet bolt…

I never recommend using grease with Nylon Bushings #TRBU11566. The grease can trap dirt which will cause the nylon to become damaged easier. And the chemicals in different greases can cause the nylon bushings to break down. If you want to use Grease…

Yes, the equalizers included in the Tandem-Axle Trailer Hanger Kit #AP233-H248 measure 2 inches tall (from eye hole to eye hole on center). I have attached a diagram to assist.

I do have a solution that will work with your EZ Lube axles. It sounds like the grease fitting is too long and is hitting the rubber cap. Most grease caps are very similar in height, so changing the cap most likely won't solve the clearance…

The Trailer Coupler Lock #e98887 will work with a UFP A-60 coupler like your Dexter A-60 #DX56FR. The product picture for this lock shows it being used on an A-60.

Yes, the etrailer Surge Brake Coupler Lock #e98888 will allow you to lock the Dexter DX7.5L A-60 Brake Actuator #DX56FR to your 2" hitch ball. We also have the Blue Ox Hitch Receiver and Coupler Latch Lock Set #BLU36XR if you want a matching…

Thanks for the info you listed. Based on that the correct replacement motor is the part #LC295380.