TorkLift Trailer Hitch - Custom Fit Hitch - TLC1204 Review Video

The TorkLift Custom Frame-Mounted Camper Tie Downs #TLC2204 and #TLC3206 that you referenced are designed to fit the 2003 Chevy Silverado 2500 with the 8 foot bed (without a board/step under the bed and without a trailer hitch). If you have the…

Hitch extenders can add enough length to give a better turning radius but the problem is that they cut the tongue weight capacity of the hitch by 50 percent. So your best option would be to go with a longer ball mount to gain the extra clearance…

Thanks for the photo it was really helpful and based on that, you do have the OEM hitch for your 2003 Chevy Silverado 2500HD. The hitch is unique in that it has the same open-end on the tubes, the same brackets, and same chain loops, which are all…

Yes, the Happijac Qwik-Load turnbuckles are very similar to the Torklift Turnbuckles like the #TLS9529-2-LK so they would work fine.

I recommend the TorkLift SuperHitch Original Trailer Hitch Receiver, part #TLC1205 for your Silverado if you have an 8-ft bed on your truck. If you have a 6-1/2 ft bed the hitch I recommend is part #TLC1204. As far as the extension you will need to…

The only TorkLift trailer hitch that fits your 2005 GMC Sierra 2500 short bed is #TLC1204. This is the SuperHitch Original Class V hitch with dual 2 inch receivers. It is rated for 1,700 pounds tongue weight and 17,000 pounds gross trailer weight.…

We haven't had the chance to install the Curt Class V Trailer Hitch Receiver #C15703 on the 2008 Chevy Silverado 2500 so I don't have exactly how far beneath the bumper the receiver will sit, however I did go out to our warehouse to take a…

For the weight you are pulling with your 2007 Chevy Silverado 2500 short bed 4x4 Duramax, I recommend the Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs - Rear Axle #F2700. These air springs are adjustable from 5 psi to 150 psi and…

I don't know what specific weight distribution system you have but our longer shanks like the Equal-i-zer part #EQ90-02-4600 which is 18 inches long and would give you additional clearance. This would also have the weight capacity you'd need…

Using the extra long Equal-i-zer Weight Dist Shank #EQ90-02-4600 referenced in your question will be your best option for gaining clearance between your truck's tailgate and jack/weight distribution system. The shank has an overall length of 18…

Since flat beds are longer than regular truck beds situations like yours can occur more often than with a regular truck. Using a longer ball mount or a hitch extender is a viable option. Since the longest ball mount with an 8 inch drop is #C45338. It…

The only thing I can think of is to back the truck up to the trailer at the same angle as it was when it was hitting the trailer before. Then back up so that the trailer ball is 6 inches away from the coupler, and see if that is going to provide…