Review of Timbren Trailer Leaf Spring Suspension - Suspension Enhancement Underslung Axle - T92MR Video

The Timbren Trailer Suspension Enhancement System for Underslung Axles #T92MR is 5-1/4" tall. Timbren recommends The spring be in constant contact with the frame at all times. So ideally you will want exactly 5-1/4" from your axle tube to…

Some trailers do have shock absorbers; it isn't all that common but is gaining popularity, mostly among camping trailers. The main reason it's not too common is most people aren't worried about the ride being that smooth. Usually the…

Hey Beatrice, To find the right fit for your trailer's suspension you'll need to take a quick measurement of your current shackle straps. You'll need to measure from the center of one bolt hole to the center of the other bolt hole. The…

From the mounting surface on the frame of your trailer down to the axle center on the Timbren Silent Ride part #TSR3500S06 measures 5-1/4 inches. You would need to compare that to your current setup to determine if that would change the ground…

The brackets on the SumoSprings Trailer Helper Springs #SS26MV are 1-1/2" wide so they will fit evenly across the humps on your spring pads. I do not recommend cutting down the spring and you will be able to use these even with only having…

I do have an option for you but the Lippert Components Bolt-On Shock Kit like part #LC281281 is designed for use on overslung axles (leaf springs over axle) only. Therefore, it should not be used with the underslung (leaf springs under axle) axles…

It sounds like you are looking for the correct braking assemblies and hubs/drums from a Dexter D52 Axle. If that is the case then we have just what you need, the Dexter Nev-R-Adjust Electric Trailer Brake Kit part #23-458-459 and the Dexter Trailer…

Yes, the MORryde Suspension Upgrade Kit #MR46ZR that you referenced is correct replacement wet bolt, bushing, and shackle kit for the CRE3000 kit that you have.

When measuring a trailer leaf spring it has to be done with no weight on the spring. You can do this by jacking up one side of the trailer and measuring the spring on that side. Or by removing a spring. It is likely that the springs on your trailer…

If you are getting inside tire wear on the rear axle of your fifth wheel that would indicate that your trailer is sitting a little nose high and putting additional stress on the rear axle. If you look at your trailer when it's connected to your…

You will measure the MORryde Suspension Upgrade Kit for Tandem Axle Trailers #MR76ZR from the center of each hole on the shackle strap.

The recommended clearance with leaf spring suspension on an unloaded trailer is between 2 - 2-1/2 inches. You should have sufficient clearance with your loaded trailer, as leaf springs only tend to deflect 1-1/2 inch when carrying a load.