Review of Stromberg Carlson Trailer Jack - 7-Way and Chain Holder - JET-30 Video

I do have a couple options for you to consider. The first is the Fastway Tethered 7-Way Trailer Connector Cover #FA82-00-3315. This is a rubber cover that tethers to the 7-way that you can use to cover the end of the connector. Next is the Optronics…

It is not recommend to jack up a trailer by the axle. This may cause damage to the axle itself. It also puts too much stress on the leaf springs. Instead, you will want to place the jack under part of the trailer frame preferably next to the leaf…

The measurement I believe you're looking for on the BoatBuckle G2 ratchet straps, part #IMF08893, is about 4-1/2 inches. I've attached a picture that shows the dimension. If this isn't the correct measurement let me know.

The Powerbuilt Unijack #ALL620470 referenced in your question has a weight capacity of 4,000 pounds. This is likely enough for your 8,200 pound trailer, but I recommend going up a bit with the Unijack #ALL620471 that is rated for 6,000 pounds. This…

I went out to the warehouse to measure BoatBuckle G2 Retractable, Ratcheting Transom Tie-Downs #IMF08893. The overall width at the widest point is 4-5/8 inches. The mounting hole is right in the center so from either edge to the center of the…

When the Powerbuilt Unijack #ALL620470 is in it's lowest position it's overall height is 8-5/8 inches. When fully extended the height is 18-3/8 inches.

I definitely understand how safety chain capacities and determining exactly what chain rating you need for your trailer can be a bit confusing. To keep it as simple as possible, safety chain requirements state that the breaking strength of EACH…

Since the Curt S-Hook with Wire Keeper for Safety Chains and Cables, part #C81820 is made of 7/16 inch diameter zinc coated steel, I recommend using something like a vise or channel locks if available to crimp the end around your safety chains. If…

The 7/16" Curt Hook with Spring Loaded Safety Latch item #C81277 is rated SAE Class II. The 9/16" item #C81288 hook is rated SAE Class III.

While we do not have an all-in-one device like the Stromberg Carlson Hitching Post Chain and 7-Way Plug Holder for Trailer Jacks #JET-30 for square tube jacks, I do have another possible solution. Instead, take a look at the: -Bauer Products 7-Way…

There are many ways you can secure wires to a trailer. I would not recommend the use of tape as it will wear out quickly when exposed to the elements. Soldering is also not recommended because it is a more permanent method and you may need to change…

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…