Review of Stromberg Carlson Four Camper Jack - Trailer Jack 7 Pads - SC53VR Video

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

We have the Swagman E-Spec Bike Rack for 2 Electric Bikes - 2" Hitches - Frame Mount #S94FR which is approved for use behind a camper trailer like what you have and has a 70 lb capacity. This is approved for use behind a travel trailer,…

I have a great alternative bike rack for your Lectric 2.0 XP 3-inch fat bike. Unfortunately, with your fenders and rear platform, I do not recommend the Saris SuperClamp HD 2 Bike Platform Rack - 2" Hitches #SAR44VR because the wheel-mount…

If you're getting this error then you'd want to use more blocks, like part #A10-0918, so that you won't have to extend the legs of your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote #LC358590 as…

As long as your Andersen Blocks are 9" in diameter and have a lip of around 1/8" you should be fine using the SnapPad XTRA Jack Pads for Lippert Leveling Systems w/ 9" Round Jack Feet - Qty 4 Item #SP54FR4. If you have issues keeping…

The Stromberg Carlson Replacement Motor #LG-196308 and the Lippert HD Motor #LC196308 referenced in your question are essentially the same motor. They can be used interchangeably on a landing gear system. With this in mind, I simply recommend…

Ths shorter school buses are built on van cutaway chassis. So since your bus is built on a 2002 GMC Savana Cutaway chassis the Buyers Products hitch part #3371801102 that you referenced would fit and work well.

SnapPads like part #SP54FR4 are not able to be used under the Stromberg Carlson Base Pad Extreme #SC33VR as they wouldn't properly fit the base of the base pads. The base pads can be used under the SnapPads to help clear up large gaps though. You…

The Stromberg Carlson Base Pad Extreme for RVs and Trailers #SC33VR can be used for short term or long term use.

Yes the gear box part #LC276602 does work with the motor you are getting part #LC196308. This motor and gear box design is very common and there is a lot of overlap between part numbers that fit both.

In order to trim the bumper fascia on a 2021 Ram 2500 when installing the Draw-Tite Front Mount Trailer Hitch Receiver part #DT36MR you will need to measure using the diagram in the instructions which I have attached a photo of below. That said,…

Yes, the SumoSprings #SS26MV is the same as the TSS-107-47 that you mentioned.