Lippert Components Trailer Jack LC377962 Review Video

Really you're going to need to measure the distance where the leveling system is going to be installed. If that distance is more than 20', then you're going to want the 6 point Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling…

Curt recommends for the Q24 that you lubricate before each individual use and every 1,000 miles thereafter. Black graphite grease is recommended for the jaw. For a grease gun the part #L30416 would work great since it has a flexible line.

I don't know what type of brackets were used on your 2022 Heartland RV Torque 5th Wheel but we carry the #LC349975, which can really only be installed at one height since they have lip that butts up against the bottom of the I-Beam. If clearance…

Yes, the Replacement Foot Pad for Lippert Hydrualic Leveling System #LC324269 will work with your Lippert Level Up system, on your 2018 Coachman SportsCoach 407FW. I have attached a picture of this foot pad being used on a Level Up system.

The easiest solution is going to be to use the adapter part #20142. This plugs into the 7-way on your Land Rover and has diodes installed in it already so that it can be used with a trailer that has LED taillights like what you have.

Because the gross weight rating on the 2018 Dutchmen Endurance 3556 is greater than 15,500 pounds you will need to use the 6-point Ground Control system #LC675817. The 4-point system is not recommended for this application.

The total weight of the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC675817 that you referenced is 350 lbs.

I spoke with my contact at Lippert and he informed me that the lights flashing indicate the low point of the coach and that if you perform a zero point calibration you will correct that. In the service manual you will need to follow the instructions…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

To manually reset your Lippert Ground Control part #LC358590 you need to hold down the retract and enter buttons at the same time. Try that but if you still get an error code you most likely have a low voltage battery that needs to be charged. Or if…

There are a couple of options that'll work great with your Lippert Turning Point Pin Box, however one hitch stands out to me more than others. Take a look at the: -Curt E16 5th Wheel Trailer Hitch - Slide Bar Jaw - 16,000 lbs #C16115 This 5th…

You'd need to put a battery in your trailer so that you can power the trailer lights when you aren't connected to your tow vehicle. It would be a matter of just running a power wire from the battery to the lights. You'd need to charge the…