Hopkins Vehicle Organizer - Trash Can - HM72651 Review Video

There isn't a tow bar that will attach to the plow or the mounting structure for the plow. I can tell you all the parts you will need but honestly, if it is just a one-time need, you would be better off having the truck towed. It will save you a…

The Equal-i-zer Shank part #EQ90-02-4900 would be your best option to give you the amount of drop you need to tow your trailer level. The Curt shank you have now part #C17131 can do up to 2 inches of drop but the Equal-i-zer can do up to 6 inches so…

From the image you attached, I think what you have is each of the taillight circuits on your 4-way have two wires ran to them for each side of the trailers wiring. You can wire the two wires of each pin to the single wires of a new 4-way allowing the…

I recommend moving away from the Adapter 4-Pole to 5-Pole Trailer Wiring Adapter #47515 and going with a Buyers Products Trailer Connector Adapter #337TC1474P. The wiring and connectors used on the 4-way harness are not designed to be used with the…

Connecting the brown running light wire in standard 4-pole wiring to both tail lights will require a jumper wire from one side of the trailer to the other, or you can install what's called a wishbone harness that has dual brown running light…

If you don't have brake or turn signals on the right side of your trailers then the most likely cause of this issue is just a blown fuse, F81 in the engine bay fuse box which is a yellow 20 amp. If the fuse is good then check the wiring behind…

What you have is a 4-way wishbone harness like part #A35W42B. It's a 4-way with two brown wires so you can run a running light circuit down each side of the trailer and not have to use a jumper wire to go from one side to the other. It makes…

The standard 4 Flat will have the White (ground), Brown (running lights), Yellow (left turn and brake), and Green (right turn and brake). Black will typically be used for 12 volt power, but can also be any number of things. The only way to know for…

Did you have a 4-pin connector that had 5 wires or was it a 5-pin connector? There is a big difference since you normally see a 5-pin connector on a boat trailer with the 5th pin used for an electric reverse lockout solenoid on a brake actuating…

I went out to the warehouse and pulled a 35 ft. Wishbone 4-Way Trailer Wiring Harness, #A35W42B, and used a wire gauge tool to measure the wires. The copper wire itself is 20 gauge. If you measure the wire with the insulation on it then it is thicker…

In order to remove a Thule lock core you first need to make sure it is unlocked by the key that matches it. Then you will need to use the larger universal key which should have been included with your bike rack; if you don't have one then you can…

No type of adapter will be necessary to use the Thule Hullavator #TH898 with WingBar Load Bars, as they will fit into the channels of those bars. For your 2011 Audi Q5 you can install the Thule WingBar Crossbars #TH711220 (Black) or #TH711200…