Hopkins Pop Up Trash Can Review Video

There isn't a tow bar that will attach to the plow or the mounting structure for the plow. I can tell you all the parts you will need but honestly, if it is just a one-time need, you would be better off having the truck towed. It will save you a…

Trailer stabilizer jacks like #TJSCHD-24 are not designed to be used to lift a trailer and hold it up for maintenance. Their purpose is to stabilize the trailer while it's parked and no more. What you're looking for is a jack to hold the…

The Equal-i-zer Shank part #EQ90-02-4900 would be your best option to give you the amount of drop you need to tow your trailer level. The Curt shank you have now part #C17131 can do up to 2 inches of drop but the Equal-i-zer can do up to 6 inches so…

Some newer cars, vans and small trucks, especially those with large, aftermarket tires, may require the use of Class S chains. Class S tire chains are designed for use on vehicles with restricted wheel well clearance. I have attached a photo that…

From the image you attached, I think what you have is each of the taillight circuits on your 4-way have two wires ran to them for each side of the trailers wiring. You can wire the two wires of each pin to the single wires of a new 4-way allowing the…

A vehicle end wiring harness using a 4-Way Flat connector should have 3 female plugs and 1 male pin. A matching 4-Way Flat trailer connector would have 3 male pins and 1 female plug like on the Mighty Cord Adapter 4-Way Flat to 6-Way Round, part…

Did you have a 4-pin connector that had 5 wires or was it a 5-pin connector? There is a big difference since you normally see a 5-pin connector on a boat trailer with the 5th pin used for an electric reverse lockout solenoid on a brake actuating…

Going by the colors that you mentioned, it sounds like you have the typical set-up, green wire for right turn and brake, white wire for ground, yellow wire for left turn and brake, brown with green wire for right side running lights, and brown with…

Connecting the brown running light wire in standard 4-pole wiring to both tail lights will require a jumper wire from one side of the trailer to the other, or you can install what's called a wishbone harness that has dual brown running light…

If you don't have brake or turn signals on the right side of your trailers then the most likely cause of this issue is just a blown fuse, F81 in the engine bay fuse box which is a yellow 20 amp. If the fuse is good then check the wiring behind…

The standard 4 Flat will have the White (ground), Brown (running lights), Yellow (left turn and brake), and Green (right turn and brake). Black will typically be used for 12 volt power, but can also be any number of things. The only way to know for…

I recommend moving away from the Adapter 4-Pole to 5-Pole Trailer Wiring Adapter #47515 and going with a Buyers Products Trailer Connector Adapter #337TC1474P. The wiring and connectors used on the 4-way harness are not designed to be used with the…