Review of CURT Trailer Cargo Organizers - Wall Mount For 2 Inch Hitch Accessories - C97DR Video

Yes, you can use the Curt Dual Hitch Extender for 2" Trailer Hitches #D-192 upside down without issue if you are looking to drop the height of your hitch-mounted bike rack. The dual hitch comes with a pin and clip to secure it to your hitch…

The Curt Dual Hitch Extender #D-192 that you referenced can be flipped if you were to use the bottom receiver for a hitch-mounted accessory (bike rack, cargo carrier, etc), but I don't recommend doing this if you still plan on using the…

First, thanks so much for the nice words, they are really appreciated. And I have good news for you as your Trek Verve+2 Lowstep bike is absolutely compatible with the OnRamp, which is the following part number: - Yakima OnRamp Bike Rack for 2…

A bike rack that holds the bike by the tops of the tires like the Yakima #Y02443 HoldUp wouldn't be the best choice for your style of bike because the presence of the fenders would prevent the rack's arms from getting a good grip on the…

Wheel-mount bike racks like the Thule T2 Pro XTR #TH83JV aren't the best options for bikes with fenders for exactly the reason you mentioned. The ratcheting hooks would come down on the fender instead of the wheel which won't provide a secure…

The Equal-i-zer Shank part #EQ90-02-4900 would be your best option to give you the amount of drop you need to tow your trailer level. The Curt shank you have now part #C17131 can do up to 2 inches of drop but the Equal-i-zer can do up to 6 inches so…

Going by the colors that you mentioned, it sounds like you have the typical set-up, green wire for right turn and brake, white wire for ground, yellow wire for left turn and brake, brown with green wire for right side running lights, and brown with…

From the image you attached, I think what you have is each of the taillight circuits on your 4-way have two wires ran to them for each side of the trailers wiring. You can wire the two wires of each pin to the single wires of a new 4-way allowing the…

Did you have a 4-pin connector that had 5 wires or was it a 5-pin connector? There is a big difference since you normally see a 5-pin connector on a boat trailer with the 5th pin used for an electric reverse lockout solenoid on a brake actuating…

If you don't have brake or turn signals on the right side of your trailers then the most likely cause of this issue is just a blown fuse, F81 in the engine bay fuse box which is a yellow 20 amp. If the fuse is good then check the wiring behind…

The standard 4 Flat will have the White (ground), Brown (running lights), Yellow (left turn and brake), and Green (right turn and brake). Black will typically be used for 12 volt power, but can also be any number of things. The only way to know for…

A vehicle end wiring harness using a 4-Way Flat connector should have 3 female plugs and 1 male pin. A matching 4-Way Flat trailer connector would have 3 male pins and 1 female plug like on the Mighty Cord Adapter 4-Way Flat to 6-Way Round, part…