Review of Fastway e2 Weight Distribution Shank 2 Inch - FA92-02-4213 Video

I'm not sure which you consider to be the top since the Fastway shank, part #FA92-02-4213, can be flipped so I went ahead and took both measurements. Although, there's very little difference. I found that in the drop position from the…

The Fastway e2 Weight Distribution Shank #FA92-02-4213 is a great option, but if you're needing a little more drop then I recommend picking up the Shank #FA92-02-4214 instead because it offers an additional 2" of drop so you can…

Yes the Curt weight distribution shank part #C17100 is perfectly compatible with the Fastway e2 weight distribution system you have.

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like…

Since your 2021 Ford Explorer ST has a 560lb tongue weight rating I recommend the Fastway e2 Weight Distribution w/ 2-Point Sway Control - Trunnion - 8,000 lbs GTW, 800 lbs TW #FA92-00-0800 which works with tongue weights between 400-800lbs. The…

Personally I would go ahead and install the Timbren suspension enhancement since it is a pretty easy install on your 2021 Ram 1500, and see if it provides enough support for your needs. If you find it does not provide the support you are looking…

The correct replacement hardware kit for your Fastway e2 4.5k system is the Replacement Hardware Kit for Fastway e2 Weight Distribution Head #FA92-02-9600. The Replacement Bolts for Equal-i-zer Weight Distribution Head #EQ90-02-9400 you asked about…

Eight inches from the ground to the bottom of your weight distribution shank would be fine for most situations but like you've experienced turning into inclined driveways can cause it to drag. Your trailer must sit pretty low to call for…

I attached an install video that uses the 7-way adapter part #37185 and a Tekonsha brake controller but it would be the same process as any Curt brake controller like the #C24VV since the wire colors are the same.

The flashing output of a Curt Triflex normally indicates that the brake pedal is pressed but a trailer isn't connected. Since yours is flasing all the time that would indicate that you most likely have a short between the 12 volt power wire for…

That means that your Curt Triflex brake controller part #C24VV is putting out "1.1" braking power to your trailer brakes. That's the initial braking power that applies and then from there it will apply more braking power based on how…

This is a common issue when there is corrosion built up on the brake output pin of the 7-way. What this does is cause the controller to sense a slight amperage draw which confuses it into thinking a trailer is connected. The other thing you can try…