Install Video for 2007 Ford F-150 Installing Brake Controller Using 7-Way Adapter

Question

Question:

I need a video to explain the install of these items

asked by: Jack S

0

Expert Reply:

I attached an install video that uses the 7-way adapter part # 37185 and a Tekonsha brake controller but it would be the same process as any Curt brake controller like the # C24VV since the wire colors are the same.

expert reply by: Jameson C

0

Answer 1

The Fastway e2 Weight Distribution Shank #FA92-02-4213 is a great option, but if you're needing a little more drop then I recommend picking up the Shank #FA92-02-4214 instead because it offers an additional 2" of drop so you can…

view full answer...

Answer 2

I'm not sure which you consider to be the top since the Fastway shank, part #FA92-02-4213, can be flipped so I went ahead and took both measurements. Although, there's very little difference. I found that in the drop position from the…

view full answer...

Answer 3

Since your 2021 Ford Explorer ST has a 560lb tongue weight rating I recommend the Fastway e2 Weight Distribution w/ 2-Point Sway Control - Trunnion - 8,000 lbs GTW, 800 lbs TW #FA92-00-0800 which works with tongue weights between 400-800lbs. The…

view full answer...

Answer 4

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under…

view full answer...

Answer 5

Brake controllers are designed to be on all the time and leaving yours on would not be an issue at all. The reason you don't want to cut power to the controller is that you'd lose all your settings if you did so.

view full answer...

Answer 6

According to the owner's manual for the Curt TriFlex Trailer Brake Controller part #C24VV, the controller will display output settings without a trailer connected. I have attached for you below an excerpt from page 5 that explains this. "The…

view full answer...

Answer 7

L.1 is the lowest sensitivity that the Curt Tri-Flex part #C24VV can be adjusted down to. However, you can also adjust the overall brake output power with the output control. The output control thumbwheel can be adjusted from the lowest setting all…

view full answer...

Answer 8

The issue is most likely on the trailer instead of a brake controller like #C24VV for example. I know you said you adjusted the brakes but I recommend adjusting the brakes more. Take a look at our video on how we adjust trailer brake assemblies,…

view full answer...

Answer 9

The flashing output of a Curt Triflex normally indicates that the brake pedal is pressed but a trailer isn't connected. Since yours is flasing all the time that would indicate that you most likely have a short between the 12 volt power wire for…

view full answer...

Answer 10

Yes a proportional Curt controller like the part #C24VV could easily replace a #C74VV. It would be just a matter of unplugging the old controller and plugging in the new one. For suspension enhancement I would go with the Timbren kit part #TJRJK…

view full answer...

Answer 11

Curt brake controllers like the TriFlex #C24VV should show a red light when the brake pedal is pressed, even when the trailer is not connected. This is just the way that Curt designed them to show they are still receiving the signal even though they…

view full answer...

Answer 12

If your Curt TriFlex Trailer Brake Controller #C24VV is just showing R then most likely you will need to recalibrate the controller. To do this, you can unplug and then plug back in the connector on your trailer. You will know it's recalibrated…

view full answer...