Curt Custom Fit Vehicle Wiring - Trailer Hitch Wiring - C56027 Review Video

For the trailer wiring harness part #C56027 the green wire goes to the passenger side rear taillight assembly and the connector with the yellow wire goes to the driver side. I also attached an install video for this for you to check out as well on…

Sounds like you have a roll pan bumper installed on your 2006 GMC Sierra based on what you described which we have hitch fits for like with the etrailer part #e82AR which will fit behind the rear license plate bracket of the roll pan bumper like…

Yes, when we installed the Curt hitch part #13424 on a similar 2015 Buick Enclave we were able to reinstall the cover as you can see in the attached install video below.

We have everything you'll need to tow a small cargo trailer with your 2017 Buick Enclave. The first thing you need is a hitch like the etrailer #e98863 which has the 5,000 lb trailer weight capacity you are wanting and is also hidden behind the…

The Curt Class III Receiver Hitch #13424 referenced in your question, which is confirmed to fit your 2017 Chevy Traverse, does require that the fascia door panel be removed during installation. Once the trailer hitch is installed, it is unlikely that…

When determining rise you don't need to factor in the height of the hitch ball unless it's a high rise ball. The rise calculation is done by taking the measurement from the top of the hitch opening down to the ground and comparing it to the…

Due to the design of the 2021 Chevy TrailBlazer the only way to install a hitch like the #C94UR would be by removing the rear bumper cover and beam since that just happens to be the only safe and strong enough location for the hitch to mount. There…

When installing the Curt Trailer Hitch Receiver #C94UR, you need to trim a 2-5/8" wide by 1-3/8" tall square into the underbody panel as seen in the instructions that I attached for you. I also attached a section of the instructions that…

If you don't already have a wiring connector on your 2012 Chevy Traverse then that means you don't have the tow package and you need to install a 4-Way wiring harness and an adapter for a 7-Way. I am not sure what factory plug you found but…

The Curt Vehicle Wiring Harness #C94FR that you referenced is supposed to be used if your 2019 GMC Terrain came with the factory tow package. If those fuse locations are empty, then it sounds like you don't have the factory tow package. As of…

In order to determine if a 2020 GMC Terrain has the factory tow package you will need to take a look in the rear fuse box on the driver side of the vehicle. In the fuse box there will be two locations you need to check, K2 and K3 which are for the…