Review of CE Smith Boat Trailer Parts - Roller and Bunk Parts - CE29505 Video

This will depend on the exact boat loaded on the trailer but seeing the Keel Roller #CE29505 mounted where it is only makes it understandable the boat will rest on the roller when loaded. If your boat does not touch the roller please send me a…

The center section of the #YR800Y that you referenced is 2-1/4 inches in diameter.

Thanks for the photo. It does indeed look like you need to move your keel rollers up towards the bottom of the boat until they are touching but not supporting the full weight. Therefore, marking the bracket when the rollers are flush to the bottom…

The CE Smith Keel Roller for Boat Trailers - Self Centering - PVC - 12" - 5/8" Shaft - Amber #CE29505 will work just fine on your boat trailer with bunks. The correct height will be dependent on the design of your boat and how tall…

The CE Smith Keel Roller for Boat Trailers - Self Centering #CE29505 is a replacement roller for a keel roller assembly. This self-centering roller fits a 12" wide bracket with a 5/8" shaft. In order to use this on your boat trailer…

The step height for the Jif Marine Hinged Dock Ladder - 5 Steps - 750 lbs - Aluminum - 4" Deep Step #JIF67FR is 12". This is the same as the rung to rung measurement. In other words, each step is 12" apart.

Most keel rollers for boat trailers like the CE Smith Keel Roller for Boat Trailers part #CE29519 or CE Smith Keel Roller for Boat Trailers - Self Centering part #CE29505 don't have listed weight capacities as they aren't supporting…

The CE Smith Deep V Keel Roller Assembly part #CE10455G will do an excellent job of helping to guide the boat out of the water and position it onto the boat trailer all while reducing the stress on your winch. However, using just one of the rollers…

You could use the CE Smith Keel Roller for Boat Trailers - Self Centering - PVC - 12" - 5/8" Shaft - Amber but you would need to have new brackets welded on to your 2015 EZ loader boat trailer, or you could drill new holes so you…

The general rule of thumb is that you want your bunks to extend completely to the stern (rear) of the boat, or even and inch or two beyond. That way the transom has plenty of support as you drive down the road. The bunks can extend as far forward as…

There are some mounting holes started on the sides of the Yates Keel Pad #YR1203SB. You simply need to acquire mounting hardware from your local hardware or home improvement store to mount these on the crossmember of your boat trailer. Mounting…

I called my contact at Yates Rubber and asked about the Keel Roller for Boat Trailers, part #YR1200Y. They told me that the weight capacity is 400 lbs. They also said that they are typically used to help as a guide and the bunks normally handle the…