Buyers Products Wiring 3376391104 Review Video

The ThermaHeat RV Dump Valve Pipe and Elbow Heating Pad #277-000162 pulls 0.3 amps and the ThermaHeat RV Holding Tank or Step Heater Pad #277-000164 pulls 4.8 amps. Assuming that you're having them all run off the same switch and wiring you would…

You will not want to install a heater like the RV Holding Tank Heater #372HTH-A between the metal straps supporting it and the tank as it can't be in contact with a conductive surface. This heater is 30" long x 13" wide but there are…

You do need to make sure you are properly connected to fuses for a single unit as the #277-000163. This is a thermostatically controlled pad. If you are running more than one, you need to run them parallel. It would be wise to use a combined amperage…

The Therma Heat heating pad #277-000164 is thermostat-controlled, automatically turning on at 45 degrees Fahrenheit and turning off at 67 degrees Fahrenheit. I do not recommend applying insulation over the heating pad as this could retain enough heat…

Yes the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat - 18-1/4" Long x 12" Wide #277-000164 can be ran off of a 12v DC power source only. I reached out to the manufacturer to verify.

If the wire from the battery to the Universal-Design Rocker Switch #PK34360 melted when installing the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat #277-000163 it may have been that you simply need to use thicker wire, and I recommend…

It sounds like you have a heating pad like the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat #277-000164. I reached out to my contact at Lasalle Bristol and they recommend using 3M Hi Strength 90 spray adhesive to reattach the pad to…

You can absolutely do that, and we do have just what you need! To wire the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat #277-000164, I recommend using the: -Universal-Design Rocker Switch #PK34310.

Though I do not know exactly how much your converter sends to the trailer batteries while hooked up to shore power, I would be willing to bet it exceeds the 4.8 amps of the ThermaHeat RV Holding Tank Heater Pad part #277-000164. Please keep in mind…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…