Review of Blaylock Industries Trailer Coupler Locks - Surround Lock - BLTL-33-40D Video

Without having a key or the key code for your Master Lock 1-7/8", 2", and 2-5/16" Trailer Coupler Lock #ML377KA your only option would be to contact a local locksmith. There is no guarantee they will be able to create a replacement key…

The physical difference in terms of appearance between various well-known gooseneck coupler manufacturers is hard to spot because they all are fairly similar. The biggest difference comes with the width of the coupler flange. The best way to…

The large round washer included with the #BLTL-51 measures 2 inches in diameter, the inner diameter is 13/16 of an inch and the washer is .139 thick. I'll provide a photo showing these dimensions.

The MasterLock High Security King Pin Lock, Item #ML387, is not compatible with your Big Tex Gooseneck Trailer. The MasterLock is for fifth wheel trailers and will not work with gooseneck trailers. We do have some gooseneck locks like the the…

If the trailer is less than 1 inch off of being perfectly level either up or down then it will be perfectly fine. Having it slightly higher would be better because presumably the tongue weight of the trailer will pull it down a little. You could also…

If you tilt the head of a weight distribution system like the #RP66083 back away from the front of the tow vehicle you will apply more spring bar tension which will effectively move more trailer tongue weight to the front axle of the tow vehicle.…

It sounds like you are asking if your weight distribution system needs to be readjusted if the vehicle has been lifted/leveled since it was setup and if so then yes, you will need to change the hitch head height adjustment on the weight distribution…

Thanks for the pictures! The only thing I would recommend changing on your set up is to add a shank with a deeper drop. I recommend the Curt Weight Distribution Shank 13" Long item #C17124 which has a 9" drop. This would move the bars below…

Since the Demco Trailer Coupler #DM14040-81 that you referenced has a lock pin hole with a diameter of 5/16" and a minimum span of 3" for the pin lock, the BOLT Trailer Coupler Lock #BL7025285 that you referenced is compatible. The pin…

The trailer frame mounted brackets for the Curt Short-Arm Weight Distribution System #C17422 should be positioned on the trailer so that the chain hangs directly down to the spring bar. The picture you mentioned is simply the studio photo we took…

On a weight distribution system you will engage the spring bars after the trailer is loaded. It is not likely that you would damage the weight distribution system as you unload the trailer. The tension on the spring bars could change though which is…

You can back up a trailer with a weight distribution system installed on as long as you don't end up in too tight of a turn. This is especially true with the Curt Weight Distribution System part #C17422 as it has a friction sway control system as…