Pulley Block for Hauling Disabled Vehicles off Car Hauler
Question:
I have a two position car hauler trailer with a winch at the front for loading disabled vehicles. I am seeking a cable guide to mount in the deck at the rear of the trailer to use the winch as assistance in removing disabled vehicles once they are loaded. Basically the cable be looped from under this pulley and thread back towards the vehicle to connect to the rear to the vehicles frame, so I can use the winch to pull the vehicles off. Do you have such a thing?
asked by: Thomas C
Expert Reply:
It sounds like you're looking for a pulley block like part # BDW20004. I would think some sort of D-ring tied into the frame of the trailer would provide a good mount for the pulley block. I looked through our selection of D-rings, and the highest capacity we offer is the # RR5K. You'd want something with sufficient capacity to handle the largest vehicle you expect to have to haul off. Since you're dealing with a rolling load, 5K should be plenty but I would be sure that the ring is tied into the structure of the framing of the trailer, instead of just being bolted to the deck.
Products Referenced in This Question
Bulldog Pulley Block for Powersports
- Accessories and Parts
- Electric Winch
- Pulleys and Snatch Blocks
- Pulley Block
- 4000 lbs
- Bulldog Winch
more information >
Brophy D-Ring Tie Down Anchor w Backing Plate - Bolt-On - 1/2" Wide - Recessed - 1,600 lbs
- Tie Down Anchors
- Trailer Tie-Down Anchors
- Truck Tie-Down Anchors
- Tie-Down Cleats and Rings
- 1600 lbs
- D-Ring
- Surface Mount - Bolt-On
- Brophy
more information >
Product Page this Question was Asked From
Erickson Bolt-On Tow Hook with Keeper - Black - 10,000 lbs
- Tow Hooks
- Standard Tow Hook
- Bolt-On Hook
- 10000 lbs GTW
- Steel
- Black
- Erickson
more information >
Continue Researching
- Video: ComeUp Electric Winch CU881080 Review
- Video: Bulldog Winch Electric Winch BDW20049 Review
- Video: Bulldog Winch Snatch Block BDW20005 Review
- Search Results: etrack
- Search Results: snatch
- Search Results: emergency brake cable
- Search Results: battery charger
- Search Results: shackle only
- Search Results: solar panel
- Search Results: shackle
- Q&A: Recommended Pulley Block To Use With Offset Winch On Trailer
- Q&A: Capacity of ComeUp CU881081 Winch Pulley/Snatch Block
- Q&A: Recommended Winch to Load 4,000 lb Tractor onto Flat Bed Trailer
- Q&A: Hand Winch for a Car Trailer and 2000 to 3500 Pound Cars
- Q&A: Can ComeUp Snatch Block part # CU881080 be Used with 3/16 inch Wire Rope
- Q&A: Pulley Block Recommendation for Trailer
- Shop: Red Bow Shackle with Screw Pin - 3/4" Diameter - 9,500 lbs
- Shop: Laclede 5/16" Quick Link for 1/4" Safety Chains - 880 lbs Working Load Limit - Qty 1
- Shop: Pollak Black Plastic, 7-Pole, RV-Style Trailer Connector - Trailer End
- Shop: Bulldog Winch Snatch Block - Silver Zinc Coated
- Shop: Curt Threaded Quick Link - 5/16" Diameter - 1,760 lbs
- Shop: Bulldog Winch Trailer Winch - Wire Rope - Roller Fairlead - 4,400 lbs
- Shop: ComeUp Snatch Block for DV-2500i, DV-3500i,DV- 4500i, Cub 4, and Cub 4s Winches
- Shop: Trailer Wiring
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Hitch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Brake Controller