Will Air Lift Air Bag Kit Fit a 2018 GMC Sierra 1500 with a 1" Taller Block at the Back of the Truck

Question

Question:

I’m interested in purchasing an airlift 5000 kit from you for 2018 GMC Sierra 1500 similar to you video from 4yrs ago. I replaced the stock rear block between axle and leaf springs to level truck out after the front got a leveling kit. Will the airlift 5000 still work with the 1” taller block that is in place currently? Thank you

asked by: Doug

0

Expert Reply:

The Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers # AL88204 will fit with your lifted 2018 GMC Sierra 1500 but you might need to add a spacer kit if you had to lift the back of your truck. Since you didn't have to lift it up too much the 2" Spacer # AL52420 should get the job done for you.

expert reply by: Jon G

0

Answer 1

The air bags that come in the Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers #AL88204 has a 5" - 7" standard operating distance and the difference is just dependent on how much room you have available. So…

view full answer...

Answer 2

Yes, the Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers #AL88204 will work with your vehicle if it is lifted but you are going to need spacers. To determine the size of spacer you need you'll need too measure…

view full answer...

Answer 3

You can install suspension enhancement on your 2016 Ram 1500 that has a 6 inch lift like the Air Lift LoadLifter 5000 Air Helper Springs #AL57365 (this is correct kit for your truck) but you do need the correct size spacer like you mentioned. The…

view full answer...

Answer 4

Yes, the Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers #AL88211 comes with two separate Schrader valves so that you can air up each air spring individually. If you're also looking for a dual path on-board…

view full answer...

Answer 5

First you will want to completely deflate the airbags. Then to remove the air line from a push to connect fitting like part #F3128-1 you first push the outer metal ring inward and then pull the air line out. You may also need to push in on the air…

view full answer...

Answer 6

To know what pin box will replace your MORryde pin box you'll first need to identify the bolt pattern. To do this you can follow the steps in the attached pin box identification article. This article will show you the different styles of pin…

view full answer...

Answer 7

For your 2012 Ram 2500, you are correct that either suspension enhancement system will work. However there are major differences between them functionally. The Timbren system #TDR2500CA is a very solid jounce spring. It is a strong Aeon hollow rubber…

view full answer...

Answer 8

In my experience with the truck only receiving a 1" lift in the back you should not need a riser. The 1" lift is often achieved with a type of spacer and since the factory springs will settle over time this usually results in less than a…

view full answer...

Answer 9

By far the best way to ensure a level ride as you are towing with your 2017 Ram 1500 with a 2 inch lift is using air bags. They allow you to set the psi to the exact amount you need in order to get a level ride as opposed to jounce springs which can…

view full answer...

Answer 10

No, the Air Lift LoadLifter Air Springs, #AL88204, will not impact the everyday ride height of your 2016 GMC Sierra 1500. The Air Lift air bags, as explained previously, do need at least 5 lbs of air to maintain the shape and prevent any damage to…

view full answer...

Will Air Lift Air Bag Kit Fit a 2018 GMC Sierra 1500 with a 1" Taller Block at the Back of the Truck

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching