Transmission Fluid Temperature Gauge and Cooler Recommendation for a 2013 Dodge Caravan

Question

Question:

I am planning to install a transmission oil temperature gauge on a dodge caravan. Will it be on the transmission line or better on the transmission oil pan. What derale kit do I need. I think the dodge caravan transmission is Chryslers 62TE model.

asked by: Carlos B

0

Expert Reply:

For a temperature gauge you could use to monitor the temperature of the transmission fluid in your 2013 Dodge Grand Caravan I would recommend the # D13009 for a mechanical gauge. This will require you to drill into the transmission pan to install the fitting and sending unit. I attached a picture that shows how it installs on a transmission fluid pan.

For a transmission cooler to help reduce the temperature of the tranny fluid you could use the Derale Series 9000 Plate-Fin Transmission Cooler Kit # D13611. I attached an install video plus an FAQ on tranny coolers for you to check out as well.

expert reply by: Jameson C

0

click to enlarge

Answer 1

It sounds like your Grand Caravan is wired like the Jeep Grand Cherokee. I have confirmed this by speaking with my contact at Tekonsha. He tells me that the wire you located is indeed the brake control output circuit. This wire would be ran through…

view full answer...

Answer 2

Your understanding of the GVWR is correct...it is the total loaded weight of the trailer and the cargo. For your 2013 Grand Caravan, I do suggest a weight distribution system along with sway control because you are very close to your max capacity…

view full answer...

Answer 3

I recommend installing the Derale Universal Drain Plug Kit #D13010 on your 2012 Ram 2500 transmission oil pan where it protected from any road debris. As with any drain plug you will want it on the lowest portion of the pan away from anything that…

view full answer...

Answer 4

The + sign on the right-hand terminal on the Derale Transmission Temperature Gauge #D13009 is for connection to an ignition-controlled 12V power source. The middle terminal connects to a chassis ground. Both connections require 18-gauge wire. The…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The Mount-n-Lock SafetyStruts Universal Kit #MO34VR includes the Standoff Spacers #MO54VR along with drill bits and the components found in the Standard Kit #MO22FR. The standoff spacers allow for mounting on I-beams shorter than 6".

view full answer...

Answer 8

From how you're describing your set up, it sounds like your bumper is attached to a tube frame, and there is a way for you to install the support brackets, which are the following part number: - Mount-n-Lock SafetyStruts Universal RV Bumper…

view full answer...

Answer 9

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

view full answer...

Transmission Fluid Temperature Gauge and Cooler Recommendation for a 2013 Dodge Caravan

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching