How to Wire Titan EHB Adapter # T4845900 to Titan Brake Rite Electric Over Hydraulic Brake Actuator

Question

Question:

Bought elec-hydraulic brake adapter 4846002 No instructions at all for installation. Please re: with instructions. Thanks

asked by: Jim T

0

Expert Reply:

The Titan # T4845900 EHB adapter plugs directly into the Titan Acuator # T4813102 between the actuator and the battery. This actuator is a Plug and Play kit.

expert reply by: Mike L

0

click to enlarge

Answer 1

You can bypass the factory brake controller on a 2012 Dodge Ram but there are a few things to do first. To install an aftermarket brake controller on a 2012 Dodge Ram that has the factory integrated controller you will have to disconnect the ITBM…

view full answer...

Answer 2

Other than there being an issue with the controller itself, you may want to check the towing fuses to male sure they are all still good. I included a picture of the fuse box under your hood and the fuses you will need to make sure are good, but it is…

view full answer...

Answer 3

The #T4845900 should work just fine on your BrakeRite SD. The connectors you sent in a picture of look to be the matching ones. That being said you could cut off the connectors and then hardwire the blue and white wires to the system like in the…

view full answer...

Answer 4

According to Dexter, their electric over hydraulic actuators should be compatible with the OE brake controllers, but in practice we find that is not always the case. We have found that the GM OE brake controller is not compatible with other electric…

view full answer...

Answer 5

I have attached a photo for you below which shows how both a vehicle side and trailer side trailer connector is typically wired. I say typically because this is not always exact and so long as the trailer and vehicle side both match it will not…

view full answer...

Answer 6

EOH actuators do differ in their response time. From the moment you press the brake pedal the time needed for the pump in the EOH actuator to build hydraulic pressure and push that through your brake lines, through the T fittings, and to your disc…

view full answer...

Answer 7

Installing the P3 brake controller #90195 on your 2015 Chevy Silverado 2500 with factory integrated controller will actually be very simple. What you will do is use harness #3016 which plugs into a port on the truck already. But you will need to…

view full answer...

Answer 8

I have attached the wiring diagram for the Titan BrakeRite EHB Electric-Hydraulic Actuator #T4822500 that you referenced. This particular actuator is designed for use with hydraulic drum brakes and features 1,000 psi of hydraulic pressure. I have…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Yes, the TrackTowers part #Y52AV does fit into Yakima HD tracks like what you have installed on your trailer.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

This will depend on if you have disc or drum brakes on your triple axle boat trailer. Disc Brake Kit #HS381-9067 Drum Brake Kit #HS381-9066 Each kit contains the correct electric over hydraulic actuator, 7-way wiring and breakaway components. If you…

view full answer...