How to Remove Old Thule T3 Cradle Strap And Install a New One

Question

Question:

hello, i ordered replacement t3 straps. today i tried to replace the straps but could not remove the phillips screws from the cap. is there a trick?

asked by: Afshin

0

Expert Reply:

If the cap at the end of the bike rack arm has a rivet instead of a screw to hold it on (check on the bottom of the arm) then you will not be able to remove it. But what you can do to get strap # 753-3535 installed is essentially stretch it out enough to go over everything, including the cradle.

I have actually done this myself and made a video of it. You basically have to work it on there by stretching and moving it as you go.

expert reply by: Michael H

0

Answer 1

The hole in the yellow octagon is offset from the center which when installed in the slotted hanger like the part #LC303918 gives you the ability to set an exact alignment with the other sides hanger but using the same configuration by simply…

view full answer...

Answer 2

The inner diameter of the Replacement Hold Fast Cradle #852-3005-002 is 1-1/4 inches.

view full answer...

Answer 3

The fittings of the MB Sturgis Sturgi-Stay T-Fitting w/ Hose for POL Valve #103609-MBS do not require any teflon tape when installing. They have rubber gaskets built into them to provide the seal.

view full answer...

Answer 4

If you live in an area where it is currently cold (since this is February) then the issue is that the rubber strap like part #753-3535 are being difficult to stretch due to the cold. Try heating the rubber straps up a little by taking the bike rack…

view full answer...

Answer 5

I checked with Thule for you and we do have the replacement parts for your Thule Helium Aero bike rack, though keep in mind the whole cradle is not available, just the cradle overmold (the top part); what you need is the following: - Replacement…

view full answer...

Answer 6

I called Thule and they confirmed the correct strap for your Thule spare Me 963XT is the Replacement Rubber Strap T2 Bike Carrier Cradles #753-3535. The Replacement Straps for Cradles on Thule Bike Racks #TH534 is not a fit your Thule Spare Me…

view full answer...

Answer 7

It looks like you purchased the Thule T3 Cradle, #853-5829, and the T3 Strap, #753-3535. These two items should work well together so I made a short demonstration video for you. If you think you may have received a different strap or are missing a…

view full answer...

How to Remove Old Thule T3 Cradle Strap And Install a New One

Product Page this Question was Asked From

Continue Researching