Replacement Anti-Sway Attachment, Strap, and Cradle Overmold for Thule Helium Aero 2 Bike Rack

Question

Question:

I need replacement parts for my Thule Helium Aero for two bikes. I need the anti sway attachments, the the replacement cradles, along with the anti sway straps. Could you give me part numbers for all these? Thanks so much!

asked by: Teresa E

0

Expert Reply:

I checked with Thule for you and we do have the replacement parts for your Thule Helium Aero bike rack, though keep in mind the whole cradle is not available, just the cradle overmold (the top part); what you need is the following:

- Replacement Anti-Sway Attachment # 852-3037-001

- Replacement Strap for Cradles on Thule Bike Racks # 852-3006-001

- Replacement Cradle Overmold # 852-3003-001

I have added links below to some video reviews for you to check out as well if you'd like.

expert reply by: Kyle S

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

You can try hairspray, but if the cradles are new they shouldn't move that easily. You can also put a single layer of electrical tape around the arms of the rack to add space and friction to the cradle assembly. What bike rack did you install the…

view full answer...

Answer 4

At the ends of the arms on Thule bike racks that take the Hold Fast cradle #7521513002 there are end caps that usually have to be removed in order to remove the old cradles and put on the new ones. These caps can either have a screw holding them on…

view full answer...

Answer 5

The Thule Gateway #TH9006XT and the Apex both should have 1-1/4 inch diameter arms so you should be able to fit replacement cradle #7521513002. The cradles on both are known as Hold Fast cradles its just that the ones on the Apex are upgraded with…

view full answer...

Answer 6

We can help you with spare keys for your any of your Thule products including roof rack, bike carriers and other accessories. All Thule lock cores have a code lightly stamped into the face; this is all you need to order the correct replacement keys.…

view full answer...

Answer 7

Since the frame cradles you are looking for are designed to fit a 1-1/4 inch arm we have a solution but it's not the #Y8890158 which fits a different size. Instead you could use the Hollywood Racks #HR750-P and you'd be set.

view full answer...

Answer 8

When replacing the Replacement Hold Fast Cradle for Thule Archway and Apex Bike Racks #7521513002, the previous cradles may have screws in which case you can just reuse them and be done with it. If it happens to have rivets, which you can look on…

view full answer...

Answer 9

The Thule Apex XT 4 Bike Rack #TH9025XT uses the Thule One-Key System. On the end of the lock cylinder it will have the key code N followed by three numbers. If you can provide me with this I can determine if a replacement key is available. Otherwise…

view full answer...

Replacement Anti-Sway Attachment, Strap, and Cradle Overmold for Thule Helium Aero 2 Bike Rack

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching