Outer Diameter of the Mounting Bracket Tube of the Pro Series Swivel Jack
Question:
I need to replace a bent jack that already has the bracket welded on. I can remove the jack by removing the snap ring and would like to just use the existing bracket for the new jack. The swivel stud pipe measures 2.5inch OD and the female jacks side of the swivel is just a hair bigger. Can you confirm either the ID of the jack side of the swivel joint or the male OD of the swivel bracket side? Thanks!
asked by: Noel D
Helpful Expert Reply:
I went out into our warehouse and measure the mounting bracket tube of the Pro Series Swivel Jack part # PS1400300303 and found that the outer diameter of the bracket that attaches to the trailer is 2-1/2 inches. Based on that this jack should work for you.
Product Page this Question was Asked From
Pro Series Round, Snap-Ring Swivel Jack - Bolt On - Topwind - 10" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Topwind Jack
- 10 Inch Lift
- Bolt-On
- With Rectangle Foot
- Pro Series
more information >
Continue Researching
- Q&A: Looking for a Bolt-On Jack That is Less Than 11 Inches When Attached
- Q&A: Recommended Bolt-On 2,000 Pound Swivel Jack for Trailer
- Q&A: Swivel Jack for 6 Inch Tall and 4 Inch Wide Trailer Frame
- Q&A: How to Remove the Snap-Ring on the Bulldog Round Snap-Ring Swivel Jack # BD151101
- Shop: Pro Series Round, Snap-Ring Swivel Jack - Bolt On - Topwind - 10" Lift - 2,000 lbs
- Q&A: Dimensions of Mounting Bracket on the Bulldog Round, Snap-Ring Swivel Jack # BD151101
- Q&A: Replacing an Older Fulton Swivel Jack for a Bulldog or Pro Series Swivel Jack
- Q&A: Difference Between Pro Series Trailer Jack # PS1400800383 and Bulldog Trailer Jacks
- Shop: Replacement Weld-On L-Bend Bracket for Bulldog and Fulton Snap-Ring Swivel Jacks
- Shop: Replacement Mounting Bracket for etrailer and Ram Snap Ring Swivel Jacks - Weld On
- Shop: Bulldog Round, Snap-Ring Swivel Jack - Sidewind - 10" Lift - 2,000 lbs
- Shop: Bulldog Round, Snap-Ring Swivel Jack - Sidewind - 15-1/4" Lift - 2,000 lbs
- Search Results: trailer jack
- Search Results: bulldog trailer jack
- Video: Choosing the Right Trailer Wiring
- Shop: Trailer Hitch
- Shop: Dust Cap for Kodiak Disc Brake Kit
- Search Results: 44649
- Article: Trailer Wiring Diagrams
- Video: etrailer Class III Trailer Hitch Installation - 2016 Jeep Cherokee
- Shop: Trailer Wiring
- Shop: Optronics LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 10 Diodes - Red Lens
- Search Results: 68149
- Article: How to Choose the Right Trailer Hitch Class
- Search Results: 25580
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Fifth Wheel Hitch
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Video: Choosing the Right Brake Controller
- Shop: Brake Controller