What is the Extended Vertical Height of the Brophy Scissor Steps part # SS03

Question

Question:

We have built a deck that sets out from our 2011 Silverado3. It is 35-36inch high - will these steps mount on that height. I think I understand that the bracket would actually be 5inch above the first top step and the first step itself is actually the 30inch maximum height. If correct...they would be perfect for us. So is the 30inch measured from the top bracket or the first step?

asked by: Laura C

0

Expert Reply:

The extended vertical height of the Scissor Steps part # SS03 is 30 inches from the top bracket. Based on that this product should work very well for what you are doing since the height you are looking for steps for is 35-36 inches.

expert reply by: Jameson C

0

Answer 1

There are steps that can work for your Northwind camper and I recommend checking out the Brophy Camper Scissor Steps #SS03 which is a triple step that will work with your 24" height. These are not permanently mounted; instead you install a…

view full answer...

Answer 2

The Brophy Universal Mount Steel Scissor Steps #SS03 have a height when extended of between 24- and 30-inches. You can measure your truck's bed height to see if this will allow the bottom cross piece (below the lowest step) to reach the ground…

view full answer...

Answer 3

Steps like the Scissor Steps #SS03 come with a bracket that gets permanently mounted to the camper, but the steps themselves get removed while traveling.

view full answer...

Answer 4

The Brophy scissor steps #SS03 are steel with a black powder coat. Steel can rust if it is exposed to the elements. Eventually the powder coat can get chips or scratches in it exposing the steel and then it can start to rust. If you notice scratches…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

What is the Extended Vertical Height of the Brophy Scissor Steps part # SS03

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching