Trailer Jack Recommendations for a Yakima Rack and Roll Trailer

Question

Question:

I am looking for a jack with a wheel for my new Yakama Rack and Roll trailer with the tongue extension. Can I install the Fulton F1410050149 jack on my trailer without too much hassle? Is there a better option that you would recommend? thanks in advance for your response.

asked by: Kevin D

0

Expert Reply:

I think your best option would be to get a Fulton Snap-Ring Swivel Marine Jack # F1410050149 like you referenced. This should attach to your 2 inch by 2 inch trailer frame and provide you with a light weight jack for your Yakima Rack and Roll trailer.

You should be careful not to exceed the weight capacity of your trailer, I am a little worried that you might be since you need a trailer jack on such a lightweight trailer.

expert reply by: Jameson C

0

Answer 1

I think your best option would be to get a Fulton Snap-Ring Swivel Marine Jack #F1410050149. This should attach to your 2 inch by 2 inch trailer frame and provide you with a light weight jack for your Yakima Rack and Roll trailer. You should be…

view full answer...

Answer 2

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer…

view full answer...

Answer 3

I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm…

view full answer...

Answer 4

The Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

We don't currently have any customer submitted photos for the Brophy Heavy Duty Cable Camper Jacks #CX74, but we do for the lower capacity #CJ74, which uses the same lift brackets. From the edge of the tube to the lift bracket is approximately…

view full answer...

Answer 7

Yes, you can! So long as our Kenda Loadstar 5.30-12 Bias Trailer Tire with 12" White Wheel item #AM30820 is the same size and bolt pattern as what's on your Ironton trailer it can be used not only as a spare but also on your trailer with the…

view full answer...