Can You Disconnect Alarm on Bright Way BW94FR

Question

Question:

Is there a way to disconnect the Alarm feature on your Bright Way BW94FR? I have mine installed inside my enclosed utility trailer so it is not readily noticeable when I unplug my 7-pin connector. Therefore, it just drains my battery.

asked by: Mark W

0

Expert Reply:

Hey Mark,

There is not a way to manually disconnect the alarm function from the # BW94FR breakaway, as it is a feature of the unit. So the alarm can't be disconnected, and if you have it on the inside of your enclosed trailer, I think I would just switch to one without that alarm, the Bright Way # 3802346.

expert reply by: Kyle S

0

Answer 1

It wouldn't be a problem to run a pigtail off of the positive and negative wires of the Bright Way battery charger #BW94FR so that you can charge it when easily when not being towed. That wouldn't affect anything at all. A replacement…

view full answer...

Answer 2

It would be a good idea to charge the Brightway kit part #BW94FR once you get it and then periodically when it is stored. To do that you would want to connect the black wire of the kit to the positive clamp and the white to the ground.

view full answer...

Answer 3

The Black wire coming from the breakaway switch would run to your junction box and connect to your brake wire terminal (this should be blue or black). The blue wire coming from the switch would go to the blue wire on the battery box. As far as…

view full answer...

Answer 4

No, the battery charger included with the Bright Way Breakaway Battery #BW94FR will not overcharge the battery no matter how far you drive. It is designed to allow the battery to fully charge, and then keep it there without damaging the battery.

view full answer...

Answer 5

Yes, the blue wire of the Bright Way Push-to-Test ICU Trailer Breakaway Kit with 0.5-Amp Charger and 5 Ah Battery #BW94FR does run to the positive post of the battery inside the box. It draws power from the battery to activate the trailer brakes in…

view full answer...

Answer 6

I apologize for any confusion on what the proper torque specs are for 1/2 inch lug nuts on trailer wheels. I attached a picture of a chart to the right that details what the proper torque specs are for a trailer wheels lugs based on lug size, wheel…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you don't have to worry about the water damaging wires like you would with electric brakes. That being said, if you use a heat shrink butt…

view full answer...

Answer 9

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Can You Disconnect Alarm on Bright Way BW94FR

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching